334DV MODE PROGRAMMING12345678910111213141516171819D Current repeater call sign programming“RPT1” or “RPT2” can store current call sign only, and re-peater call signs must be stored in the repeater list (p. 34) .q Enter “RPT1” or “RPT2” in call sign screen. MENU ¶ CALL-S ¶ RPT1 or RPT2(Push [MENU ]), (rotate [DIAL], then push [ ](MONI).)• RPT1/RPT2 call sign screen is displayed.w Push [](LOW) to enter call sign programming mode.• The 1st digit blinks.e Rotate [DIAL] to select the desired character or code.• Push [](LOW) or [](CS) to move the cursor right or left, re-spectively.rRepeat the step e to enter the desired repeater call sign.• Call sign can be up to 8 digits long.• If an unwanted character is entered, push [](LOW) or [](CS)to select the character, then push [CLR](DR) to erase the se-lected character, or push and hold [CLR](DR) for 1 sec. to eraseall characters following the cursor.t Push [ ](MONI) to store the programmed call sign andreturns to call sign screen.y Push [MENU ] to return to frequency indication.
