369TROUBLESHOOTING12345678910111213141516171819If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center.PROBLEM POSSIBLE CAUSE SOLUTION REF.No power comes on. • The battery is exhausted. • Recharge the battery pack. pp. 29–31• Bad connection for the battery pack. • Check the connection to the transceiver. p. 7No sound comes from the • Squelch level is too deep. • Set squelch to the threshold point. p. 9speaker. • Volume level is too low. • Set [VOL] to a suitable level.Transmitting impossible. • WX channels or NAVI band is selected. • Set COM band in frequency mode. p. 8• The battery is exhausted. • Recharge the battery pack. pp. 29–31Operating frequency or • Lock function is activated. • Hold down [ ] for 2 seconds to turn the lock p. 9memory channel can not function OFF.be changed.Scan does not start. • All memory channels in the selected bank are • Set the “TAG” settings of desired channels. p. 20not programmed as “TAG” channels.• Squelch is open. • Set the squelch level to tighten. p. 9• There is not more than 2 memorized channels • Program 2 or more memory channels. pp. 13, 14No beep sounds. • Beep tones turned OFF. • Turn the beep tone ON;¬ IC-A14: Push [FUNC], then push [BEEP](8). p. 22¬ IC-A14S: Turn the beep tone ON in set mode. pp. 22 , 25D CP-22 fuse replacementIf the fuse blows or the receiver stops functioning while oper-ating with the optional CP-22 CIGARETTE LIGHTER CABLE, fi ndthe source of the problem if possible, and replace the dam-aged fuse with a new rated one (FGB 8 A) as shown right.Fuse 8 A