Idis DR-6232P-S Operation Manual

Also see for DR-2204P: Installation manual Quick guide

Idis DR-6232P-S Operation Manual Manual pdf 55 page image

Part 2 - Configuration55Alarm-In● No.: Enable / disable alarm-ins.This option includes both local and network cameraalarm-ins. 1 through 16 are network camera alarm-ins,whereas 17 through 20 are local alarm-ins.● Title: Use the virtual keyboard to enter titles.● Type: Change the alarm-in type.● Actions: Specify which actions to take when Alarm-Inis detected.– Record: Specify which cameras to begin linkedrecording on when an event occurs. If the scheduleis set to Event or Time & Event mode, the selectedcameras will begin linked recording when an eventoccurs.– Alarm-Out: Designate event-triggered alarm-outchannels (each for the NVR and camera) and beeps.– Notify: Configure to be notified of events by Mail,LAN1 through 5, SNS, Push, and/or Alert Window.– EventUpload: Uploads the video clips when anevent occurs.– PTZ: Moves the PTZ camera to a specific presetposition when an event occurs.– Event Monitoring: Selects the cameras to monitorwhen an event occurs.• In order to use the Callback feature, the NVR mustbe registered on the remote program.• Select Panic Record to specify which alarm-inchannels to use. Panic Record commences whenthe corresponding alarm-in occurs and terminateswhen the alarm-in is deactivated.Video Loss● Actions: Specify which actions to take when a VideoLoss event occurs.– Record: Specify which cameras to begin linkedrecording on when an event occurs. If the scheduleis set to Event or Time & Event mode, the selectedcameras will begin linked recording when an eventoccurs.– Alarm-Out: Designate event-triggered alarm-outchannels (each for the NVR and camera) and beeps.– Notify: Configure to be notified of events by Mail,LAN1 through 5, SNS, Push, and/or Alert Window.– EventUpload: Uploads the video clips when anevent occurs.– PTZ: Moves the PTZ camera to a specific presetposition when an event occurs.– Event Monitoring: Selects the cameras to monitorwhen an event occurs.In order to use the Callback feature, the NVR must beregistered on the remote program.● Ignoring Interval: The system does not produceevent log entries or issue remote notifications forvideo loss detected for the time specified after theinitial video loss was detected. Set the value between0.1 and 15 seconds or choose Never. This is supportedonly when video encoders are connected.● Use Ignoring Time: Select Time Setup to specifythe time to ignore video loss detection. Video lossdetection will be disabled for a specified time period.This is supported only when video encoders areconnected.