Jacuzzi oortable spa Owner's Manual

www.clearcreekspas.comwww.clearcreekspas.comEquipment Set-UpINSTALLATION1. Remove the plastic sheet covering the spa. Use care;stepping into the spa with shoes will scratch the acrylicsurface.2. Remove any packing materials from the spa.3. Remove each filter cartridge from its plastic bag.4. Pull open each skimmer/filter door by the handle lo-cated in the middle of the door and remove the skimmerbasket. Then insert the filter cartridge into the filterhousing and re-insert the basket so that it fits in placeover the filter cartridge and close the skimmer/filterdoor.5. Clean the interior of the spa of any remaining construc-tion debris. Remove stubborn stains, paint, or tar withturpentine, isopropyl alcohol or paint thinner. A mildliquid dishwashing detergent on a damp cloth is fine forcleaning off other dirt. Plaster can be removed byscraping with a wooden edge; do not use a metalscraper, wire brush, or other metal tools, as they willdamage the spa’s surface.6. Install the skirt panels which were not installed on thespa at the factory. To do this, secure with the screwsprovided in your spa accessory package and followinstructions provided with panels.7. On initial start-up, it is necessary to purge and sanitizethe system. Carefully follow the procedure describedhere to purge and sanitize your spa.• Remove the spa cover completely.• Close the drain valve located on the suction tee.• Fill the spa with water to its normal operating level,which is to the water level indicator mark on theskimmer/filter frame.• Turn on circuit breakers at the main electrical panel.• Select JETS on the SYSTEM switch.• Add 60cc sodium dichlor (a fast dissolvinggranulartype of chlorine) to the water and letthe whirlpool run for 15-20 minutes only.• Turn off JETS.• Turn off circuit breakers.• Immediately open the drain valve and drainthe spa completely.CAUTION: Leave the rigid cover off the spa duringthis procedure. Do not use the spa during thisprocedure. Drain the spa immediately afterward.8. Close the drain valve and fill the spa with water toapproximately 180mm (7") below the spa rim, orto water line indicator mark on theskimmer frame. (See illustration on this page.)9. Turn on circuit breakers at the main servicepanel.10. Set the heater thermostat for the maximum tem-perature.11. Test the spa for proper operation. (Refer toOperating Instructions.)12. Refer to Water Quality section of the OperatingInstructions. Test for water quality; then addtreatment chemicals to ensure proper levels.All Jacuzzi Whirlpool Bath spas are factory tested forproper operation and watertight connections prior toshipping. If leaks or other problems are detected,immediately notify your Jacuzzi Whirlpool Bath dealeror Authorized Service Agent, or call Jacuzzi WhirlpoolBath, (510) 938-7411 (510-938-7070 in California),for Warranty Service.