Jacuzzi oortable spa Owner's Manual

www.clearcreekspas.comwww.clearcreekspas.comINSTALLATIONInstallation InstructionsInspection and Shipping ClaimCheck for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the spasustained during shipping. If damage is evident before unpacking, see instructions regarding shipping claims on the outsideof the carton and immediately file a claim with the carrier.Once the spa has been removed from the carton and before it is permanently installed (see below on this page for unpackinginstructions), check the spa completely for damage. Fill the shell with water and operate the system (see OperatingInstructions) to check for leaks which may have resulted from shipping or handling. All Jacuzzi Whirlpool Bath spas arefactory tested for proper operation and watertight connections prior to shipping. If leaks or other problems are detected,immediately notify your Jacuzzi Whirlpool Bath dealer or Authorized Service Agent, or call Jacuzzi Whirlpool Bath, (510) 938-7411, for Warranty Service, (510-938-7411).Npte: Damage or defects which could have been discovered anr repairedprior to installation and which are claimedafter final installation of the spa, are excluded from our warrenty.Unpacking1. Remove the outer carton by disassembling bracingand plastic bags. Leave the inner bag and corrugatedwrapping in place on the skirt to protect the product untilequipment set-up.2. Remove the box containing skirt panels and the acces-sory package which contains the Owner’s Manual,filter, cartridges, and extra lenses and bulbs. Set asideskirt panels until equipment set-up. Set aside the filtercartridges in a dry place until it is time to set up the spaequipment. Store the extra lenses and bulb for lateruse.3. The spa should be moved on a dolly in its uprightposition while still attached to its shipping pallet. If thepallet must be detached before the spa is moved (forexample, to allow it to pass through a door), detach itfrom the pallet as instructed below, then carefully placeit vertically on a dolly which is wide enough to supportthe entire width of the spa. The skirt is cosmetic (notstructural) and is not designed to support the spa.4. When the spa has been moved to its final location,place a wooden block approximately 100mm x 100mmx 2m (4" x 4" x 72") beside the pan side of the spa soit is parallel with the pallet. (See illustration B.)5. Tip the spa over onto its bottom with the block support-ing the spa.6. Remove the brackets attaching the spa to the pallet.(See detail B.)7. Remove the bolts securing the pallet to the upper partof the spa shell.8. Remove the 100mm x 100mm (4" x 4") block and palletand carefully lower the spa to a horizontal position.9. Attach two loose skirt panels included in skirt box.10. Record the spa serial number on the inside front coverof this manual. (See illustration on page 2 for the serialnumber location.)Important! Read all the instructions contained in theOwner’s Manual before beginning installation.DETAIL SKIRTPANPALLETBOLT