Jandy ePump Installation Manual

Contents

Jandy ePump Installation Manual Manual pdf 12 page image

Page 124.4 Last FaultThis feature shows on the top display line, the most recentunique fault message and on the bottom display line, thesecond-to-last unique fault message. If there is no entryfor a fault, the display will show “*----------------*” on thecorresponding line. To select last fault, from the service setupmenu select LAST FAULT. Press MENU.NOTE The fault messages are stored in non-volatilememory, and remain even with no power. To clear thefault history, press either arrow key.2 3 4SELECT SERVICE SETUPLAST FAULTePUMPMENU4.5 Priming Speed and DurationThe ePump™ controller will command the ePump™ tooperate at the priming speed for the priming durationspecified (except during timer program overlaps or follow-oncommands where the pump is not stopped before changingspeeds). From the service setup menu, select PRIMING usingthe arrow keys. Press MENU.2 3 4PRIMING DURATIONMIN: 3ePUMPMENUTo set priming speed, select PRIMING SPEED using thearrow keys. Press MENU. Using the arrow keys, set thepriming speed to the desired value. Press MENU to acceptand store.2 3 4PRIMING SPEEDRPM: 3450ePUMPMENUTo set priming duration, select PRIMING DURATION usingthe arrow keys. Press MENU. Using the arrow keys, set thepriming speed to the desired value in minutes from 1 to 5minutes. Press MENU to accept and store.2 3 4PRIMING DURATIONMIN: 3ePUMPMENU4.6 eStar SpeedThe "" speed is intended to be used as an energy-efficientsetting that can be easily called-up by activating the eStarpreset speed from the keypad or remote closure. After thisspeed has been determined by the installer, the eStar presetmay be set as follows: From the service setup menu, selectSET ESTAR SPEED. Press MENU. Using the arrow keys,set the speed to the desired value. Press MENU to accept andstore.2 3 41:eSTARRPM:1250ePUMPMENU4.7 Pump Freeze Protect OperationWhen enabled to do so, the ePump™ controller monitors thetemperature inside the pump and will activate the ePump™at the eStar speed when the temperature approaches freezing.The run duration of the pump freeze protect operation isadjustable from 30 minutes to 8 hours, or may be disabledcompletely.