Jandy ePump Installation Manual

Contents

Jandy ePump Installation Manual Manual pdf 13 page image

Page 13To set the pump freeze protect operation, from the servicesetup menu select PUMP FREEZE PROTECT. PressMENU. Using the arrow keys, set the duration to the desiredvalue. To disable pump freeze protect, set the duration to0:00. Press MENU to accept and store.2 3 4PUMP FREEZE PROTECT1:05ePUMPMENUImportant Information on Freeze ProtectionFreeze protection is intended to protect equipment andplumbing for short periods of freezing only. It does thisby activating the filtration pump and circulating the waterto prevent freeze inside equipment or plumbing. Freezeprotection does not guarantee that equipment will not bedamaged by extended periods of freezing temperaturesor power outages. In these conditions, the pool and spashould be shut down completely (e.g. drained of water andclosed for the winter) until warmer weather exists.The pump freeze protect run time may be interrupted bypressing a preset key, as follows:Pressing the key "" once overrides the pump freeze protectrun time, pressing it twice turns off the pump. Pressing otherpreset keys will override the pump freeze protect run time andactivate the selected preset speed.2 3 4ePUMPMENUPUMP FREEZE PROTECT1: FILTRATION4.8 Selecting Pump TypeThis feature is preset by factory default. At this time, theePump™ controller does not support other types of pumps.Section 5. User Set Up OptionsNOTE The ePump TM user interface must be in the OFFmode before entering the user setup mode. While insetup mode the user interface will return back to theOFF mode after one (1) minute since the last keypress.When in setup mode, preset keys "" through "4" are usedas ‘escape’ or exit keys while navigating the setup menu.To enter the setup mode, press and hold the MENU buttonfor five (5) seconds. The controller displays SELECT USERSETUP. Using the arrow keys, select the desired setup itemto change.5.1 Setting Time-of-DayFrom the Setup menu, select SET TIME. Press the MENUbutton to display the currently-set time. Using the arrow keys,adjust to the desired time. Press MENU to save your setting.2 3 4ePUMPMENUSELECT USER SETUPSET TIME5.2 Labeling PresetsThe ePump™ controller comes from the factory with pre-programmed labels or names for the preset speeds. The labelsmay be changed as desired to suit your particular installation.Two types of labels are provided by the controller:General Labels - selected from a list•Custom Labels - created by the user•From the setup menu, select LABEL PRESET. Press theMENU button to display the currently selected Preset. Usingthe arrow keys, choose the preset to be changed. Press MENUto select. The controller displays SELECT LABEL TYPE.Select GENERAL or CUSTOM as desired using the arrowkeys.2 3 4ePUMPMENUSELECT USER SETUPLABEL PRESET

/ 16

Related manuals for Jandy ePump