Page 94. Connect one side of the reman’s switch to theePump™ Controller at J3 REMOTE CONTROL,COMMON.5. Connect the other side of the reman’s switch to theePump™ controller at J3 REMOTE CONTROL,INPUT 4.6. Set the timeclock to the desired on/off times.7. Turn on all switches and the main breaker feedingpower to the ePump™.8 If the installation is working properly, the reman’sswitch will open 20 minutes before the boosterpump shuts down, the ePump™ will continue to runfor 30 minutes, and the ePump™ Controller willdisplay PUMP WILL REMAIN ON FOR XX:XX,where XX:XX is the time remaining until ePump™shutdown.Section 3. User Operation3.1 OFF ModeWhen the pump is off (not running), the controller displaysPRESS PRESET OR MENU/00:00 PUMP IS OFF,where 00:00 is the time-of-day clock.2 3 4PRESS PRESET OR MENU12:00AM PUMP IS OFFePUMPMENU3.2 RUN ModeWhen the pump is running (not off), the controller displaysN:LABEL/00:00 RPM:XXXX, where n:label is the numberand label of the selected preset, 00:00 is the time-of-dayclock, and xxxx is the pump speed.2:PRESET 210:00AM RPM: 1200 2 3 4ePUMPMENU3.3 Manual Start and StopUp to eight (8) programmed speeds may be started from thecontroller. Manual operation of speeds "eStar" through "4"differs from manual operation of speeds "5" through "8".NOTE When starting the pump, the pump will first run at thepriming speed for the priming duration, as set by theinstaller.3.3.1 Speeds eStar through 4To start the pump manually running at speeds "eStar" through"4", press button "" through "4" corresponding to thedesired speed. The associated LED will light red and thecontroller enters the RUN mode.2 3 4ePUMPMENU2:PRESET 210:00AM RPM: 1200 To stop the pump, press the button again. The associated LEDwill extinguish and the pump and controller will return to theOFF mode.3.3.2 Speeds 5 through 8To start the pump manually at speeds "5" through "8",press the MENU button. The controller displays SELECTPRESET/N:LABEL, where n:label is the number and labelof the last selected preset "5" through "8".Using the arrow keys, select the desired preset to activate,and then press MENU to enter RUN mode, starting the pumprunning at the selected speed.2 3 4SELECT PRESET5:PRESET 5ePUMPMENUTo stop the pump, press MENU. To exit without starting thepump, press any button "" through "4".3.4 Pump Speed SettingWith the exception of preset "", the pump speed for eachpreset may be adjusted while the pump is running in thatpreset mode. Preset "" is reserved for the eStar function,and its speed is set by the installer.

Section 1. Important Safety Instructions

save these instructions

Section 2. Installation of the User Interface

Installation of the Backplate on a Flat Wall

Connection to Remote Contacts

Section 3. User Operation

Timeclock Setup and Operation

Section 4. Service Setup Options

Last Fault

Selecting Pump Type

General Labels

Section 6. Menu Flow Chart

limited warranty

Jandy ePump Installation Manual

ePump