Jenn-Air JES8850BAF19 Use & Care Manual

Also see for JES8750BAB16: Use & care guide Installation instructions Installation instructions

Contents

Activating and canceling the clociddayof week display:1. PressSetup pad. On/Off/2. Select CLOCK. ........................................................3. Press the arrow to scroll until DISABLE is displayed.4. Select DISABLE.5. Select TIME.6. Select OFF to turn the clock display off, or select ON to turnthe clock display on.7. Select OFF to turn the day of the week display off. SelectON to turn the weekday display on.8. To exit the Setup mode, press Setup pad.Entering the day of the week:1. Press Setup pad. Setup __:2. Select CLOCK. On / Off j:.................. /3. Press the arrow to scroll until DAY is displayed.4. Use Quickset arrow to scroll through the days.5. Select day desired.6. To exit the Setup mode, press Setup pad.To set the clock for a 12 or 24 hour format:The clock can be set to display time in either a 12 hour or 24hour format.1. Press the Setup pad.2. Select CLOCK.3. Use the arrow to scroll to the next screen.4. Select 12124 HOUR.5. Select 12 HR or 24 HR.6. To exit Setup mode, press Setup pad.TimersSetting the Timers {[Timer 1 or Timer 2}:1.2.Press TIMER 1 or TIMER 2 pad.Press one of the displayed times using theQuickset pads, or press the number pads toenter the desired time./ ............................./TIMER 1"', On/Off /Important: Each press of the displayed time choices addsadditional time. For example, pressing "10 MIN" threetimes provides 30 minutes on the timer (0:30}.3. Press Enter pad.Changing the amount of time entered once theTimer starts:1. Press the TIMER 1 or TIMER 2 pad once. / TIMER 12. Press the displayed times on the Quickset ,, On / Off /pads repeatedly until the desired time is entered.OR3. Press the number pads to enter the new desired time.4. Press Enter pad.Canceling the Timer:1. Press the TIMER 1 or TIMER 2 pad twice.if both Timers are active: ,, On/Off /If the desired Timer is already in the foreground, press oncefor edit mode and twice to cancel the Timer. If the desiredTimer is not in the foreground, follow the steps below.1. Press the desired TIMER pad once. The selected Timer willcome to the foreground.2. Press the TIMER pad a secondtime to access the editmode in order to make changes.3. Pressing the TIMER pad a thirdtime will cancel the Timer.Changing the Timer beeps:The signal beeps for TIMER I and TIMER 2 can be changed.The options available are two beeps every thirty seconds, twobeeps every sixty seconds or one beep only. The defaultsetting is one beep.1. Press the Setup pad.2. Select the arrow to scroll until TONESis displayed.3. Select TONES.4.5.(' Setup. On / OffSelect TIMERS TONES.Select the desired timer beep format (2-30 SEC, 2-60 SECor 1 BEEP}.6. Press Setup pad to exit Setup mode.Locking the Control and Oven DoorThe oven control and oven door can be locked to preventaccidental programming. If an oven function is currentlybeing used, the control and door cannot be locked.To lock the control and door:Press the Back and Enter pads at the same time, holding forthree seconds or until CONTROL LOCKED appears in thedisplay.To unlock the control and door:Press the Back and Enter pads at the same time, holding forthree seconds. UNLOCKING DOOR will appear in the displaywhen the control and door are unlocking.Back 0 EnterSpace J-_ loci<14