Jenn-Air JES9750CAW00 Use & Care Manual

Also see for JES9750CAB01: Installation Instructions and Use & Care Guide Installation instructions

Jenn-Air JES9750CAW00 Use & Care Manual Manual pdf 27 page image

TROUBLESHOOTINGTry the solutions suggested here first in order to avoid the cost of an unnecessary service call.Nothing will operate Display shows messages• Has a household fuse blown, or has a circuit breakertripped? Replace the fuse or reset the circuit breaker. If theproblem continues, call an electrician.Cooktop will not operate• Is the control knob set correctly? Push in knob beforeturning to a setting.Excessive heat around cookware on cooktopIs the cookware the proper size? Use cookware about thesame size as the surface cooking area, element or surfaceburner. Cookware should not extend more than W' (1.3 cm)outside the cooking area.Hot surface indicator light stays on• Does the hot surface indicator light stay on after controlshave been turned off? See "Hot Surface Indicator Light" in"Cooktop Controls" section.Cooktop cooking results not what expectedIs the proper cookware being used? See "Cookware"section.• Is the control knob set to the proper heat level? See"Cooktop Use" section.• Is the range level? Level the range. See the InstallationInstructions.Oven door will not openHas a self-clean cycle been started? The oven door islocked during a self-clean cycle. See "Self-Cleaning Cycle"section.Is the oven control and oven door lock set? See "Lockingthe Oven Control and Oven Door" section.Oven will not operateIs the electronic oven control set correctly? See"Electronic Oven Control" section.Has a delay start been set? See "More Options" section.On some models, is the Control Lock set? See "Lockingthe Oven Control and Oven Door" section.On some models, is the Sabbath Mode set? See "SabbathMode" in the "Setup" section.Oven temperature too high or too low• Does the oven temperature calibration need adjustment?See "Temp Adjust" in the "Setup" section.• Is the display showing "FAULT DETECTED?" A fault hasbeen detected. Follow the displayed directions "PRESSENTER TO TRY AGAIN" or "DISABLE POWER TO CLEAR." Ifthe fault does not clear, reappears, or "FEATURE NOTAVAILABLE" is displayed, call for assistance or service.• Is "SAB" flashing?Oven is in Sabbath Mode. To cancel, press and hold theSETUP pad for 5 seconds.Self-Cleaningcyclewill not operate• Is the oven door open? The dislpay will show "CLOSEDOOR." Close the oven door all the way.• Has the function been entered? See "Self-Cleaning Cycle"section.• On some models, has a delay start Self-Clean cycle beenset? See "Self-Cleaning Cycle" section.• Has a delay start been set? See "More Options" section.• Is the control in Sabbath Mode? See "Sabbath Mode" inthe "Setup" section.• Is the oven temperature above 400°F (205°0)?Let the oven cool before using the self-clean cycle.Oven cooking results not what expectedIs the range level? Level the range. See the InstallationInstructions.Is the proper temperature set? Double-check the recipe ina reliable cookbook.Is the proper oven temperature calibration set? See "TempAdjust" in the "Setup" section.Was the oven preheated? See "Bake," "Broil," or "ConvectBake" section.Is the proper bakeware being used? See "Bakeware"section.Is the oven vent blocked? See "Oven Vent" section.Are the racks positioned properly? See "Positioning Racksand Bakeware" section.Is there proper air circulation around bakeware? See"Positioning Racks and Bakeware" section.Is the batter evenly distributed in the pan? Check thatbatter is level in the pan.Is the proper length of time being used? Adjust cookingtime.Has the oven door been opened while cooking? Ovenpeeking releases oven heat and can result in longer cookingtimes.• Are baked items too brown on the bottom? Move rack tohigher position in the oven.• Are pie crust edges browning early? Use aluminum foil tocover the edge of the crust and/or reduce bakingtemperature.27