O VEN LIGHTTo assure the proper replacement bulb isused, order bulb from Maytag CustomerService. Call 1-800-688-8408, ask for partnumber 74004458 - halogen bulb.20• Disconnect power to range beforereplacing light bulb.• Allow oven to cool before replacinglight bulb.• Make sure bulb cover and bulb arecool before touching.TO REPLACE OVEN LIGHT BULB:1. When oven is cool, use fingertips tograsp edge of bulb cover. Pull out andremove.2. Carefully remove old bulb by pullingstraight out of ceramic base.3. To avoid damaging or decreasing the lifeof the new bulb, do not touch the bulbwith bare hands or fingers. Hold with acloth or paper towel. Push new bulbprongs straight into small holes ofceramic base.4. Replace bulb cover by snapping intoplace.5. Reconnect power to the range. Resetclock.O VEN DOORMAINTENANCE• NEVER place excessive weight onor stand on an open oven door. Thiscould cause the range to tip over,break the door, or injure the user.• NEVER attempt to open or closedoor or operate oven until door isproperly replaced.• NEVER place fingers between hingeand front oven frame. Hinge armsare spring mounted. If accidentallyhit, the hinge will slam shut againstoven frame and could injure yourfingers. O VEN W INDOWTO PROTECT THE OVEN DOORWINDOW:1. Do not hit the glass with pots, pans,furniture, toys, or other objects.2 Do not close the oven door until theoven racks are in place.Scratching, hitting, jarring or stressing theglass may weaken its structure causing anincreased risk of breakage at a later date.LEVELING LEGS• Be sure the anti-tip bracket secures oneof the rear leveling legs to the floor. Thisbracket prevents the range from acciden-tally tipping.The range should be leveled when installed.If the range is not level, turn the plasticleveling legs, located at each corner of therange, until range is level.ANTI-TIP BRACKETLEVELING LEGANTI-TIP BRACKETLEVELING LEGTO REMOVE:1. When cool, open the oven door to thebroil stop position (opened about fourinches).2. Grasp door at each side. Do not use thedoor handle to lift door.3. Lift up evenly until door clears hingearms.TO REPLACE:1. Grasp door at each side.2. Align slots in the door with the hingearms on the range.3. Slide the door down onto the hingearms until the door is completely seatedon the hinges. Push down on the topcorners of the door to completely seatdoor on hinges. Door should not ap-pear crooked.NOTE: The oven door on a new range mayfeel “spongy” when it is closed. This isnormal and will decrease with use.CAUTION CAUTION