KERN 572 Operating Instructions Manual

Also see for 572: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Contents

KERN 572 Operating Instructions Manual Manual pdf 13 page image

4.10 The MODE-ProgramThe MODE-program can be run to make the following settings: Adjusting (see section 4.2.) Printer settings (see section 5 Interface) Counter (parts counting see section 4.6.) Percent (see section 4.7.) CLEAR (clearance function) "Fast"-setting for fast weighing (1 – 5) "Test" – (for service only) Autotare setting (ON/OFF) to stabilise the balance in the area of zero point. Auto off automatic shut off after nearly 60 sec. When not in use. Variable FaktorBelow the detailed description of the individual functions:4.10.1 The CLEAR functionThe CLEAR function serves to:a) The return to the weighing mode from the percent mode and the parts counting mode.b) Put the enumerator to zero.c) TaringCLEAR function Display1. Press MODE-key2. Press YES-keyCLEAR?0,0 g4.10.2 The Autotare settingThe Autotare setting serves to stabilise the zero point of the balance. Minor weightvariations in the zero are tared, the display remains on zero. The standard setting is:"Autotare" on. The setting can be turned off e.g. for desiccation weighing.Select/Deselect “Autotare" Display1. Press MODE-key repeatedly until display shows:2. Press NO to deselect AutotarePress YES to select Autotare3. Press MODE-key repeatedly until the balance displays ingrams again, or press TARE-key.Autotare?XAutotare?Autotare?X0,0 g572/KB/DS-BA-defsi-0246 33