KERN 572 Operating Instructions Manual

Also see for 572: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Contents

KERN 572 Operating Instructions Manual Manual pdf 16 page image

5.3 BaudrateThe Baud rate for the data transfer is adjusted with the MODE-key. The following exampledemonstrates how to set the Baud rate 4800.Select Baud rate Display1. Press MODE-key repeatedly until "PRINTER" is displayed.2. Press YES-key.3. Press MODE-key repeatedly until the desired Baud rateappears (for instance 4800 Baud).4. Press YES-key to select 4800 Baud. The tick-mark (X)confirms the new setting.5. Press MODE-key repeatedly until the balance displays ingrams again, or press tare key.PRINTER?2400 Baud4800 Baud4800 Baud X0,0 g5.4 RS 232 C Data output via interface RS 232 C5.4.1 General informationAs a condition for the data transfer between the balance and a peripheral device (forinstance printer, PC ...) both devise have to be set on the same interface parameter (forinstance baud rate, parity ...).There are 4 methods for the data output via RS 232 C1. Data output via PRINT-key (see 5.4.2).2. Data output, after having loaded the balance, by setting AUTOPRINT (see 5.4.3).3. Continuous data output by setting AUTOPRINT PC (see 5.4.4).4. Data output by transfer of remote controls (see 5.4.5)5.4.2 Data output via PRINT-KeyThe printing process can be released by the PRINT-key. In this case the settingsAUTOPRINT and AUTPRINT PC should be deselected.5.4.3 AUTOPRINTThe setting AUTOPRINT is in the PRINTER-routine, and there it can be selected ordeselected. When AUTOPRINT is active the actual weighing value will be sent via the RS232 interface when the balance has been unloaded and then loaded after having achievedthe stability.36 572/KB/DS-BA-defsi-0246

/ 19

Related manuals for KERN 572