AES/AEJ-BA-e-091282Remarks:• The performance delivered by the output control via the commands “O0~O7” orsetting the weighing balance functions is the same.• Models “O8 and O9“ are specifically designed for input commands.• Once a command of "O0~O9” has been executed its status will remain enableduntil the next command is given. However, after turning off the weighing balanceoutput control returns to initial setting.15 Printer modeThe following conditions must be met to provide successful communication betweenthe weighing balance and the printer.• Use a suitable cable to connect the weighing balance to the interface of theprinter. Faultless operation requires an adequate KERN interface cable.• Communication parameters (Baudrate, bits and parity) of weighing balanceand printer have to match, see chpt. 10.1.5 “Settings for serial interface”.15.1 How to issue an adjustment protocolFor menu settings [ ] and [ Fq QoT 1 ], see chpt. 10.1An adjustment protocol is issued after completing an adjustment/adjustment test.For sample protocols see chpt. 15.3.
