Kaba E-PLEX 50XX SERIES Operation Manual

Kaba E-PLEX 50XX SERIES Operation Manual Manual pdf 11 page image

11In this example, the lock will now remain locked for 30 seconds after threewrong Access Codes have been entered. No codes, even valid ones or theMaster Code, will work in the lock until that time period has elapsed. Only themechanical override key will open the lock during the tamper shutdown.PROCEDURE 7 - PROGRAMMING THE LOCK FORKEYPAD BUZZER VOLUMEYou might want to adjust the volume of the Keypad Buzzer depending on wherethe lock is located - a noisy or quiet area.Required User Level: Master, Manager1. Put the lock into Pushbutton Programming Mode.2. Enter the code 008#VV# (where VV is a scale of volume from00 to 03; 00 = off; 01 = Low; 02 = Normal; 03 = High).3. Example of Complete Entry: 008#02#.4. Enter another # to indicate the end of programming.5. The lock will now sound the buzzer at the desired volume Normal, untilyou change it.USER - GENERAL INFORMATION1. Master and Manager Codes can do two different things:• Open the door by entering the Access Code without # signs.• Put the lock into Pushbutton Programming Mode by entering # beforeand after their Access Code.2. Each user (Manager User, Service User or Access User) occupies one ofthe available 300 locations in the user table.3. By default, user 000 is the Master User.4. The M-Unit User is outside of the user table (only applicable with “E-PlexStandard” PC software use).5. Users have a 15-second period to enter the entire key sequence, and 5seconds between pressing each pushbutton number. If they pause longerthan 5 seconds between each pushbutton pressed, or exceed the 15-sec-ond period to enter the total sequence, the lock:• aborts the current programming sequence• automatically exits the programming state• sends the user a ‘Keypad Timeout’ feedback messageNote: Correct errors during a command sequence. If an invalid entryoccurs, recover from the mistake by entering the (*) key, which will clear allentries made from the beginning of the current command sequence, and willreset the 15-second time limit for entering the code. In this case, you stillhave 15 seconds from the first number entered to enter the whole code.