Kaba E-PLEX 50XX SERIES Operation Manual

Kaba E-PLEX 50XX SERIES Operation Manual Manual pdf 15 page image

15PROCEDURE 3 - ADD / MODIFY SERVICE USERACCESS CODEA Service User is any person who needs access to the lock for a limited timeperiod in order to perform a service, such as painting or repairs in the room orarea. A Service User Access Code allows the service person to enter, exit andre-enter using that code for a certain number of hours, up to a maximum of 24hours.Required User Level: Master, Manager1. Put the lock into Pushbutton Programming Mode.2. Enter Command 102# to add /modify a Service User Access Code.3. Enter the Service User ID location (a three-digit number you have on a listthat you should carry with you) followed by #, for example 025#.4. Enter UUUUUUUU#, representing a User Access Code of between 4 and8 numbers depending on the length of Access Code that you selected inProcedure 1 on page 7. For example, if your code length is 4 digits, it couldbe 2240#.5. Enter the code 2240# again.6. Now enter the number of hours, programmable between 01 and 24, forexample 04. If you enter a Service Access Code of 00, you can onlyenter the door once. If the door shuts upon exiting, you will not be ableto re-enter. This type of access is called a one-shot code.7. Example of Complete Entry: 102#025#2240#2240#04#.8. Enter another # to indicate the end of programming.9. The Service User Access Code 2240 will now work in that door, for thisService User for a period of 4 hours from the time the Service Userenters his Access Code the first time.PROCEDURE 4 - DELETE USER ACCESS CODESUser Access Codes should be deleted from the lock if no longer needed. Thisfrees the User ID location to be assigned to another user. Codes that may beneeded some time in the future should be de-activated rather than deleted.Required User Level: Master, Manager1. Put the lock into Pushbutton Programming Mode.2. Enter Command 200# to delete a User Access Code.3. Enter the User ID location NNN#, where NNN is the specific User IDlocation from 000 to 299.4. Example of complete entry: 200 #023#.5. Enter another # to indicate the end of programming.By deleting a User ID location, you have now also deleted the associated UserAccess Code, allowing you to assign this User ID location with a new accesscode to another user if you wish.