Kaba E-PLEX 50XX SERIES Operation Manual

Kaba E-PLEX 50XX SERIES Operation Manual Manual pdf 8 page image

8PROCEDURE 2 - MODIFY THE MASTER USER ACCESSCODERequired User Level: Master1. To change the factory code or current Master Code, follow the next threesteps:2. Put lock into Pushbutton Programming Mode.3. Use the command, 000, for Master, then the new Master Code number.4. You must use 8 digits between 00000000 and 99999999 as follows:000#MMMMMMMM#, we’ll use 000#87654321# as an example.5. Enter the Master Code again 87654321# for confirmation.6. Example of Complete Entry: 000#87654321#87654321#.7. Key in another # to indicate the end of programming.8. After that, you will always use your own Master Code. Please write the codedown and keep in a safe place. The factory code is no longer valid.PROCEDURE 3 - SET THE DATE / TIMENote: Not required if software is not usedYou must enter the current date and time in each lock to enable accurateprogramming and auditing. Always enter Standard Time; the software packagewill make the adjustment for Daylight Savings Time. These must be regularlyupdated according to your maintenance schedule. Enter 001 for date settingsand 002 for time settings. Date / time settings are kept after a battery changeunless you remove the batteries for more than two minutes. In this case, thetime is reset to 00:00:00 and the date to 01/01/00.Required User Level: Master1. Put lock into pushbutton programming mode.2. Enter the date as follows: 001#MMDDYY# (Month, Day, Year, where MM= 01 to 12; DD = 01 to 31; YY = 00 to 99. For example, Nov. 22, 2007would be entered as 112207).3. Enter the date again to confirm MMDDYY#. Example of Complete Entry:001#112207#112207#.4. For the time, enter as follows: 002#HHMM#, where HH = 00 to 23hours; MM = 00 to 59 minutes. Use military time - for example eight-thirty in the morning would be 0830, while in the evening it would be2030).5. Enter the code again HHMM#, for example 0830.6. Example of Complete Entry: 002#0830#0830#.7. Enter another # to indicate the end of programming.8. The current date and time are now programmed into the lock.