Kaba E-Plex 5200 User Manual

Also see for E-Plex 5200: Quick reference guide

Contents

Kaba E-Plex 5200 User Manual Manual pdf 115 page image

Programming and Auditing LocksE-Plex Advanced ACS User’s Guide PKG 3114 0106 5–3M-Unit User DefinitionThe E-Plex 5200 and E-Plex 5700 locks can have special M-Unit User Access credentials(PIN, Prox, or both). This credential is used only to program and/or audit the lock using theM-Unit PDA as a maintenance function only—the code will NOT open the door. When an M-Unit User presents/enters his or her M-Unit credential, the lock enters the CommunicationsMode with the M-Unit handheld PDA immediately (equivalent to entering the command#M-Unit PIN/Card#), indicated by alternate green and red flashing LEDs. Now the M-UnitUser can program the lock.Programming LocksTo program locks, the M-Unit User uses the M-Unit to transfer lock data from the E-PlexAdvanced ACS software to the E-Plex 5200/E-Plex 5700 lock.Note: Before you can transfer lock data to E-Plex 5200/E-Plex 5700 locks, you must firstprepare the data in the E-Plex Advanced ACS software. Refer to Programming Locks inchapter 3, Using the E-Plex Advanced ACS Software, for more information.Once lock data has been prepared at the PC, you are ready to transfer data to the locks.Complete the following steps to transfer data to the E-Plex 5200/E-Plex 5700 lock usingHotSync.Transferring Files from the PC to the Lock through the M-Unit1. HotSync the M-Unit. Refer to steps 1–4 of HotSyncing the M-Unit in Chapter 2, GettingStarted.Note: If it appears that the lock data did not successfully transfer to the M-Unit, youshould check to make sure that the Palm HotSync E-Plex ACS Conduit has beeninstalled on the PC.To do so, right click on the HotSync icon in the system tray of the PC. Select Customfrom the menu options to display the list of installed conduits and their actions. If“EPlexACS” is not found in the list, go to the Windows Start menu on the PC andaccess Start | Programs | E-Plex Advanced ACS | Install Palm HotSync E-PlexACS Conduit to install the conduit. Then, repeat the process to upload data from thePC to the M-Unit.2. After you have transferred the files from the PC to the M-Unit, disconnect the M-Unit fromthe PC.Note: Before you can use the M-Unit to program locks, you must have entered theCustomer Key. Refer to Entering Customer Key Information Into the M-Unit inChapter 2, Getting Started, for more information.3. Go to the door you want to program.