165. DUPLICATIONThe KanguruClone HDD Duplicator can operate in either one of two duplication methods:• With a Master HDD as the source• With a Storage Center as the sourceBoth methods are described in the following sections.5.1 Duplicating From a Master HDDUsing a Master HDD as the Source is the simplest and most convenient way to perform the duplicationprocess.IMPORTANT! Connect all Master and Target hard drives before you execute an operation.To execute the duplication of a Master HDD:1. From the Main menu, tap the ‘SET’ button to navigate to the desired copy mode. For moreinformation on the different available copy modes see chapter 3. Duplication Modes on page13.The screen will display the following:Current Copy ModeNumber of Targets connectedTotal successful copies Total failed copiesNote: The system will not recognize any connected drives before duplication begins. Thereforethe “Number of Targets connected” value will always be zero until you execute the copy process.2. Once you have selected the desired copy mode, tap the ‘RUN’ button to execute. The duplicationprocess begins as the system initializes the connected disks. At this point the system will be ableto display the number of connected targets correctly.(Continued on next page)Duplicating From a Master HDD