Kanguru KCLONE-5HD-SATA User Manual

Kanguru KCLONE-5HD-SATA User Manual Manual pdf 19 page image

193. Tap the ‘RUN’ button. The duplicator will initialize the disks and then ask you to input a namefor the image file. Up to 999 files can be stored in the Storage Center (depending on the capacityof the hard drive).a) The file name consists of three digits. The digit furthest to the right will be blinking, indicatingthat it is currently selected. Tap the ‘RUN’ button to increase the digit by one.b) Tap the ‘SET’ button to select the next digit to the left. Tap the ‘RUN’ button to increase thedigit by one. Repeat this step as necessary.Note: If your duplicator displays the error message, “TARGET NOT FORMATTED” thenthe hard drive connected to the Source port has not been formatted as a Storage Center yet(see section 5.2.1 Formatting a hard drive as a Storage Center on page 18).4. When you have completed naming the image file, hold the ‘RUN’ button and the Load processwill begin.Note: If the image file name you enter already contains an image file previously loaded on theStorage Center, the system will ask you to confirm overwriting the previously saved file. Tapthe ‘RUN’ button to confirm or tap the ‘SET’ button to cancel.Size of Source dataIMG file numberPercentage completedAmount of data loadedData transfer rate5. When the load process has completed you can remove the Master HDD.5.2.3 Duplicating an image file stored on a Storage CenterNow that you have loaded an image file on the Storage Center, you can begin the copy process:1. Make sure the Storage Center is connected to the Source port.2. From the Main menu, hold the ‘SET’ button to enter the Setup menu.3. From the Setup menu, tap the ‘SET’ button to navigate to the SEL IMG FILE option.In the example above, file number 001 is currently selected.(Continued on next page)Duplicating From a Storage Center