Kanguru KCLONE-5HD-SATA User Manual

Kanguru KCLONE-5HD-SATA User Manual Manual pdf 9 page image

9Hardware Setup1.4 Hardware Setup1. Place the KanguruClone where there is proper ventilation. Avoid using the KanguruClone inenvironments with high temperatures.2. Before plugging in the AC Power Cable, please make sure that the voltage is adjusted to thesame as your local voltage 110V/220V.Note: Make sure that sufficient power is supplied to the KanguruClone. Incorrect power willcause faulty operation. It is highly recommended that you use a UPS (uninterruptible powersupply) with the KanguruClone.3. You are now ready to begin using your KanguruClone. To begin, turn on the unit with the powerswitch located on the back panel.Things to remember• Make sure that sufficient power is supplied to the KanguruClone. Incorrect power will causefaulty operation. It is highly recommended that you use a UPS (uninterruptible power supply)with the KanguruClone.• The KanguruClone is powered by an internal power supply that is controlled by a rocker switchlocated at the rear of the unit.• The KanguruClone supplies power to all drives during a cloning session. There is no need toconnect an external power source to the drives. The unit can supply up to 1.5A at 12V and up to1A at 5V to each drive.Note: the drives are not powered until you start a copy operation.• It is OK to connect and disconnect Master or Target drives while the KanguruClone is poweredon. However, do NOT connect or disconnect drives while any operation is running or is inprogress. The green LED light will blink to indicate that the unit is cloning or operating.• The supplied cables are NOT standard cables like the ones found in a PC. Do not attempt to usethese cables in a PC nor to use PC cables with the KanguruClone. Doing so may cause damageto the unit and drives.• Your the Source port is labeled ‘S’. Target ports are any other ports labeled with a number.• Connect all Master and Target hard drives before you execute an operation.