Kathrein UFD 420 Operating Manual

Also see for UFD 420: Operating manual Mode d'emploi

Kathrein UFD 420 Operating Manual Manual pdf 25 page image

Initial settings25When making the setting, it should be ensured that there is at least one blankchannel above and below the output channel in order to avoid interference.Modulator TV / VCRHere you can assign the UHF modulator to either the TV- or the VCR Scart socket.Factory presetting: assignment to the TV Scart socket.An assignment to the VCR Scart socket is recommended if, for example, yourvideo recorder is unsuitable for “VPS“ via the Scart input. In this case, connect thevideo recorder via the UHF modulator and assign the modulator to the VCR Scartsocket.OSD languageHere you can select the language for the on-screen displays. The choice availablecomprises: German, English and French.Default: GermanLNB supply voltageHere you can turn off the power supply for the feed system if this is implementedby an external power supply and signal selection is likewise not carried out bymeans of the LNB supply voltage (e.g. Kathrein single-cable feed system UAS330).Note If there are switchover matrices in the receiving system, the LNB supply voltageneeds to be turned in all cases.Default: ONLNB supply voltage in standbyWhen the receiver is in standby the LNB supply voltage is normally switched off.If terrestrial signals and satellite signals are combined in the receiving system, andthe power supply for the relevant components comes from the receiver, the powersupply must also be guaranteed when the receiver is in standby.In this case switch the power supply in standby to “On“.Default: “Off“.Programme selectionYou have the option of entering the programme number in one-, two-, or three-digitform or in “free” formDefault: “free“.Setting Settable programme slotsOne-digit input Programme slots 1 to 9Two-digit input Programme slots 1 to 99Three-digit input Programme slots 1 to 250Free input Programme slots 1 to 250Note If a recording is pre-programmed in the timer for a programme slot ≥100, the timermust be cleared first in order that a change in the programme slot entry can be car-ried out.On Screen Displays (OSD)Here you can select whether the programme slot and programme name are to be