Kathrein UFD 420 Operating Manual

Also see for UFD 420: Operating manual Mode d'emploi

Kathrein UFD 420 Operating Manual Manual pdf 27 page image

Initial settings27As a result, you can easily install the UFD 420 on other receiving systems withoutneeding to reprogramme every single programme slot.You only need to set up the particular oscillator frequencies that your receivingsystem uses.On delivery the oscillator frequencies set up are those listed in the picture below.Presetting:LO 1: Low band HorizontalLO 2: Low band VerticalLO 3: High band HorizontalLO 4: High band VerticalChanging the oscillator frequency• Call the initial setup menu (see paragraph: “Calling the initial setup menu“).• Using the keys move to menu entry“Oscillator menu . . .“.• Call up the “Oscillator selection“ submenu using the keys.• Move to the line in which you want to alter oscillator frequency (LO 1... LO 4)Various fixed pre-programmed LO frequencies can be selected with the keys.• You can enter deviant oscillator frequencies in the range from 9000 MHz to12000 MHz directly via the numeric keys ... in 5-digit form,(e.g. 11700).• Save the settings with the key (press twice).• Exit from the menu with the key.DiSEqC menuFundamentals of the DiSEqC signal (Digital Satellite Equipment Control)In order to select the satellite signals different control signals are required.Up until now, the 14/18V LNB supply voltage and the 22 kHz signal (superimposedon the LNB supply voltage) have been sufficient for signal selection for the majorityof applications.With these four control criteria it is possible to switch between horizontally and ver-tically polarised signals, as well as between two satellites (multifeed reception).With the extension of the frequency range to the 12 GHz region (high-band region11.70 – 12.75 GHz) or for reception of more than two satellites, additional controlcriteria are required for LNB selection and signal selection.The “DiSEqC“ control signal has been developed by Eutelsat in collaboration withPhilips.The “DiSEqC“ control signal is, in fact, a particular form of modulation (pulse-widthmodulation) of the already existing 22 kHz signal.