Kathrein UFD 420 Operating Manual

Also see for UFD 420: Operating manual Mode d'emploi

Kathrein UFD 420 Operating Manual Manual pdf 29 page image

Initial settings29Tone burstIn the “Tone burst“ menu entry the following settings of the 22 kHz signal are pos-sible:Switching states on setting: Switching states on setting: Switching states on setting:22 kHz signal —> High/Low andTone burst —> Pos. A/B:22 kHz signal —> Pos. A/B andTone burst —> Opt. A/B22 kHz signal —> Pos. A/B andTone burst —> High/LowLowHigh22 kHz22 kHzOffOnPos Tone burst 22 kHz LowHighTone burstTone burst01Pos. 1Pos. 2Tone burstTone burst0112340011OffOnOffOnPos. 1Pos. 222 kHz22 kHzOffOnDiSEqCUp to 16 inputs can be switched with the “DiSEqC“ control signal.• If the receiver is connected up to a “DiSEqC" switch-over matrix, the menu entrymust be set to “On”.Note For optimal usage it is essential to know the switching criteria and the input as-signments of the DiSEqC switching matrices.Thus take into account the specifications of the DiSEqC switching matrices or getin touch with the installer of the receiving system.DiSEqC repeatIf the receiver is operated on a receiving system with two or more DiSEqC switch-ing matrices connected in series (cascaded), the DiSEqC command must be re-peated.• In this case set the menu entry “DiSEqC Repeat" to “1" or “2“.Default: OffUFO miniWith a “subscriber-controlled preprocessing system" the receiver‘s input frequencyis adjusted to a fixed input frequency. The signals are transmitted by the “sub-scriber-controlled preprocessing system“ on this frequency. The reception pa-rameters for the programme selection are transmitted by “DiSEqC“ commandto the receiving system and set up there.Which setting needs to be selected "On" or “Twin“ is dependent on the design ofthe “subscriber-controlled preprocessing system“.The “UFO Twin“ design is a special form of the “subscriber-controlled preprocess-ing system“Note The setting is therefore to be made according to information in the “subscriber-controlled preprocessing system“ installation guide.Remote frequencyIf you have set "On" or “Twin“ in menu entry UFO mini, make the setting in thismenu entry for the transmission frequency.The particular transmission frequency that needs to be set for tuner A “TV“ andtuner B “VCR“, in the range 0 to 2150 MHz, is given in the “subscriber-controlledpreprocessing system“ installation guide.Note It is therefore essential to note the installation guide instructions of the “subscriber-controlled preprocessing system“.