Kathrein UFS 910 Operating Manual

Also see for UFS 910: Function guide

Contents

Kathrein UFS 910 Operating Manual Manual pdf 10 page image

10CONNECTION AND SET-UPThe following section is intended specifically for specialist dealers. You only need to pay attention to thissection if you are carrying out the installation yourself.The “Connection Examples” section provides a sample configuration.Do not connect the unit to the power supply until all installation work has been properly carried out.Refer to the information in the “Safety Instructions” section.Connect the Sat IF input on the receiver to the satellite reception system. Use a coaxialcable with a standard F connector.If the F standard connectors are not yet fi tted on the cable, strip the insulation fromthe cable as shown in the following illustration and carefully twist the F standardconnectors on to the ends of the cables until they are securely seated.When fi tting the connector, make sure that no wires from the braid are touching theinner conductor, so no short circuit can occur.The quality of the reception signal depends on this connection!The presets for the control signals have been made for standard reception systems, i.e. 14/18 V for polarityreversal and 22 kHz switching signal for low/high band changeover on multi-feed reception systems.CONNECTING THE UNIT (SAT-IF CONNECTIONS)RECEPTION REQUIREMENTSMake sure that your own satellite antenna system is equipped at least with a universalLNB for digital reception in the high-band range.RECEPTION SYSTEM PRESETS