74SERVICE MENUUSB DEVICE MANAGEMENTThis function can be used only if an external USB storage medium is connected at the rear of the receiver.For this see also page 3 “Recording function (from software version 1.04)”REMOTE CONTROL CODESelect the “Service” menu using the menu button , the buttons on the main menu and .Use the buttons to switch to “Remote control code” and to call it up press the button.The following display appears:You can now use the remote control for your receiver to set a new remote control code. Simultaneouslypress buttons + + for remote control code 1 (standard setting) + + for remote control code 2 + + for remote control code 3 + + for remote control code 4After changing the remote control code you must now set your remote control to the code you selected.For this, simultaneously press buttons + for remote control code 1 + for remote control code 2 + for remote control code 3 + for remote control code 4Then press the button. If the receiver display does not close down, the receiver and the remote controlare not set to the same remote control code. Check your settings again.This function isunavailable on thefi rst hardware versionof the UFS 910!On this, the “Remotecontrol code”selection field isgreyed out and cannotbe selected.
