Kathrein UFS 910 Operating Manual

Also see for UFS 910: Function guide

Contents

Kathrein UFS 910 Operating Manual Manual pdf 62 page image

62Network scanUse the buttons (On/Off) to select whether a network scan should be performed. If you set thenetwork scan to “Off”, only the factory stored transponders of the satellites you previously selected will bescanned for new as yet unlisted channels.If you set the network scan to “On”, the transponder network enables additional transponders that havenot yet been stored to be located. They are then stored and scanned for new channels in the same wayas the existing transponders.When you have made your settings, use the buttons to select “Start Search” and press the button to start scanning. You can cancel the scan at any time by pressing the button. During the scanyou will see a display that shows you the progress of the scan and the channels found so far. Newly foundchannels are identified with the designation “New” after thechannel name.After completion of the scan, you will see the followingmessage (example):Press the button. You will be asked whether you wish tosave the changes or not. Selection is performed using the buttons and is confirmed using the button. If youselect “Yes, save changes”, the newly found channels will be added to the end of the channel list. Then pressthe button to exit the menu. The channel list is called up on to the TV screen by pressing the button(see also section “On-screen displays” “Channel list TV/Radio”).CHANNEL SEARCH (CHANNEL SCAN)CHANNEL SCAN WITH SERVICE IDThe buttons allow you to select different sets of parameters for the scan.SatelliteUse the buttons to select the satellite that is transmitting the channels to be scanned.Make sure your reception system is aligned to the selected satellite.Press the button to move to the next selection item.