Kenwood DDX4018DAB Instruction Manual

ENGLISHiImportant NoticeImportant NoticeTo ensure proper use, please read through thismanual before using this product. It is especiallyimportant that you read and observe WARNINGSand CAUTIONS in this manual.Please keep the manual in a safe and accessibleplace for future reference.WARNINGSTo prevent accidents and damages• DO NOT install any unit or wire any cable in alocation where;– it may obstruct the steering wheel and gearshiftlever operations.– it may obstruct the operation of safety devices suchas air bags.– it may obstruct visibility.• DO NOT raise the volume level too much, as this willmake driving dangerous by blocking outside sounds,and may cause hearing loss.• DO NOT operate the unit while driving. If you needto operate the unit while driving, be sure to lookaround carefully.• Stop the car before performing any complicatedoperations.• The driver must not watch the monitor while driving.CAUTIONSTo care for the unit• If you have parked the car for a long time in hot orcold weather, wait until the temperature in the carbecomes normal before operating the unit.To care for the monitor• The monitor built into this unit has been producedwith high precision, but it may have some ineffectivedots. This is inevitable and is not considereddefective.• Do not expose the monitor to direct sunlight.• Do not operate the touch panel using a ball-pointpen or similar tool with a sharp tip.Touch the keys on the touch panel with your fingerdirectly (if you are wearing a glove, take it off).• When the temperature is very cold or very hot...– Chemical changes occur inside, causingmalfunction.– Pictures may not appear clearly or may moveslowly. Pictures may not be synchronized withthe sound or picture quality may decline in suchenvironments.On the volume setting• Digital devices produce very little noise comparedwith other sources. Lower the volume before playingthese digital sources to avoid damaging the speakersby sudden increase of the output level.The marking of products using lasersThe label is attached to the chassis/case and saysthat the component uses laser beams that have beenclassified as Class 1. It means that the unit is utilizinglaser beams that are of a weaker class. There is nodanger of hazardous radiation outside the unit.For Israel