Kenwood DNX7310BT Instruction Manual

Contents

7272 73Return to the Top pageSetting UpReturn to the Top pageSetting UpTravel Prayer for Safe Drive Setting(DNX7310BTM/ DNX5310BTM only)When this function is set, the prayer fordriving safety is displayed when the unit isturned on, then Quran is played.1 Touch [SET] of [Travel Prayer for SafeDrive] in the User Interface screen.Travel Prayer for Safe Drive Setting screenappears.2 Set each item as follows.Travel Prayer for Safe DriveTurns the Safe drive pray function on or off.Sound VolumeSets the sound volume of Quran.Touch panel adjustment1 Touch [Touch] in the System Menuscreen.Touch Panel Adjustment screen appears.2 Follow the instruction on the screenand touch the center of each .NOTE• To cancel the touch panel adjustment, touch[Cancel].• To reset to the initial status, touch [Reset].Security setupA red indicator will blink on the unit after theACC is set to OFF, warning potential thieves.If turned to “ON” (default), the securityindicator on the front panel flashes when thevehicle ignition is off.1 Touch [Security] in the System Menuscreen.Security screen appears.2 Touch [ON] of [SI].NOTE• If “SI” is turned on, the SI indicator on the subpanel flashes when the vehicle ignition is off andthe panel is detached. Default is “ON”.3 Touch [SET] of [Security Code Set].NOTE• If you have already completed the coderegistration, [CLR] is displayed.4 Enter a security code with four-digitnumber and touch [Enter].5 Enter the same code again and touch[Enter].Security code is registered.NOTE• If you enter a different security code, the screenreturns to step 4 (for the first code entry).• If you have pressed button or if youhave disconnected the Receiver from battery,enter the correct security code as that you haveentered in step 4 and touch [Enter]. You can useyour Receiver.EXT SW setupSet up the external switch power mode.1 Touch [EXT SW] in the System Menuscreen.EXT SW screen appears.2 Set each item as follows.SW NameSets the name of the external device.Output PatternSets the power signal output mode among“Pulse”/“Level”. Default is “Pulse”.You can set to turn output on/off each timethe button on the EXT SW screen is touched.See External Device Control (P.81).Pulse SetSets the pulse signal output time.Outputs 500ms when “1” is set.Increases by 200ms with each step. Up to 100steps can be set.NOTE• You can enter characters only after you haveapplied the parking brake.• “Pulse”: Generates a single power signal pulse.• “Level”: Continues output of high power signal.