Kenwood DNX7310BT Instruction Manual

Contents

8686 87Return to the Top pageAudio Setting UpReturn to the Top pageAudio Setting UpDSP selectYou can select whether using DSP (DigitalSignal Processor) System.1 Touch [Bypass] or [Through] of [DSPSelect] in the Audio SETUP screen.BypassThere is no effect by DSP.ThroughThere is an effect by DSP.NOTE• When the mode is set to [Bypass], DSP Systemcannot be adjusted.ElevationYou can raise the sound position heard fromthe speakers virtually.1 Touch [Elevation] in the Audio SETUPscreen.Elevation screen appears.2 Select Elevation level from [High],[Low], and [OFF].Controlling General Audio1 Touch [Audio Control].2 Set each item as follows.Fader #/Balance #Adjust the volume balance around thetouched area.[2] and [3] adjust the right and left volumebalance.[5] and [∞] adjust the front and rear volumebalance.Volume Offset*Finely adjust the volume of the current sourceto minimize the difference in volume betweendifferent sources.Subwoofer LevelAdjusts the subwoofer volume. This setting isnot available when subwoofer is set to “None”.See Speaker setup (P.82).Bass BoostSets the amount of bass boost among “OFF”/“Level1”/ “Level2”/ “Level3”.LoudnessTurns the loudness control function on oroff. If turned on, high and low tones areautomatically enhanced during low volume.Settable only when zone function (P.90) isset to off.* If you have increased the volume first, thenreduced the volume using the “VolumeOffset”, the sound generated if yousuddenly switch to another source may beextremely loud.