Kenwood DNX7330BT Instruction Manual

114114 115Return to the Top pageTroubleshootingReturn to the Top pageTroubleshootingError Message Cause SolutionUSB DeviceError!!The connected USB device is rateda current capacity higher than theallowable limit.Check the USB device. Some trouble may haveoccurred to the connected USB device.Change the source to any source other thanUSB. Remove the USB device.AuthorizationErrorConnection to the iPod has failed. • Remove the iPod and then reconnect it.• The unit does not support the iPod.See Connectable iPod/iPhone (P.118).Update youriPodThe iPod’s software is an olderversion which the unit can notsupport.The unit may not support the connected iPodmodel.Confirm that the software for the iPod is thelatest version.See Connectable iPod/iPhone (P.118).NavigationError. Pleaseturn on poweragain later.The communication error hasoccurred due to severely coldtemperature.Turn on power again after warming your carinterior.Antenna Error The antenna has a short-circuit andthe protective circuit has activated.Check the Digital Radio antenna. If a passiveantenna without a booster is used, set AntennaPower “OFF”.Resetting the UnitIf the unit or the connected unit fails tooperate properly, reset the unit.1 Press the button.The unit returns to factory settings.NOTE• Disconnect the USB device before pressing the button. Pressing the buttonwith the USB device connected can damagethe data stored in the USB device. For how todisconnect the USB device, see How to PlayMedia (P.15).• When the unit is turned on after resetting, theInitial SETUP screen appears. See Initial setup(P.13).