Kenwood DPX-MP6110U Instruction Manual

English | 17Audio AdjustmentsCabin selectionYou can compensate the delay of the sound arrivaltime, which is caused by the installation position ofthe speakers, by selecting your environment fromthe following car types;Car type (rear speaker position) DisplayNot compensating. “OFF”Compact car (rear door) “Compact1”Compact car (cargo) “Compact2”Full size car (rear door) “Full Size Car1”Full size car (cargo) “Full Size Car2”Station wagon (rear door) “Wagon1”Station wagon (cargo) “Wagon2”Minivan (rear door) “Minivan1”Minivan (cargo) “Minivan2”Sport-utility vehicle (rear door) “SUV1”Sport-utility vehicle (cargo) “SUV2”Minivan Long (rear door) “Minivan(Long)1”Minivan Long (cargo) “Minivan(Long)2”Calls the value adjusted at (page 17). “User”1 Enter Cabin select modeSelect “SOUND” > “S-SET” > “CABIN”.For how to select Function Control item, refer to (page 6).2 Select the car typeTurn the Control knob.3 Exit Cabin select modePress the [FNC] button.⁄• You can compensate the distances in more details byusing (page 17) function.In addition, the value specified at can be calledby selecting “User”.2 Select the speaker you want to setSetting speaker DisplayFront speaker “DTA-Front”Rear speaker “DTA-Rear"Subwoofer “DTA-Sub"Turn the Control knob and push the centerwhen the desired item is displayed.3 Set the compensation value of the speakerpositionTurn the Control knob.Adjust between 0 and 440 cm.Refer to (page 25) on how to set thecompensation value.4 Exit DTA setting modePress the [FNC] button.X’Over settingYou can set a X’Over value for the speakers;Adjustment Item Display RangeFront High Pass Filter “HPF-Front” Through/40/60/80/100/120/150/180/220 HzRear High Pass Filter “HPF-Rear” Through/40/60/80/100/120/150/180/220 HzLow Pass Filter “LPF” 50/60/80/100/120/ThroughHzSubwoofer level “SUB-W LEVEL” –15 — +15Subwoofer Phase “SW PHASE” Reverse (180°)/ Normal (0°)1 Enter X’Over setting modeSelect “SOUND” > “S-SET” > “XOVER”.For how to select Function Control item, refer to (page 6).2 Select the item you want to setTurn the Control knob and push the centerwhen the desired item is displayed.3 Set the X’Over valueTurn the Control knob.4 Exit X’Over setting modePress the [FNC] button.DTA (Digital Time Alignment) settingAdjusting fine tuning of the speaker positioncompensation value specified at (page 17).1 Enter DTA setting modeSelect “SOUND” > “S-SET” > “DTA”.For how to select Function Control item, refer to (page 6).