|
English | 25• DISP REVERSESwitches the panel display between positiveor negative. In addition, you can reverse it inconjunction with the interior light.POSI 1 : Displays the text in the positive.POSI 2 : When the interior light is off, the text isdisplayed in the positive; when the interiorlight is on, the text is displayed in thenegative.NEGA 1 : Displays the text in the negative.NEGA 2 : When the interior light is off, the textis displayed in the negative; when theinterior light is on, the text is displayed inthe positive.• CabinThe position of front and rear speakers may nothave the same distance from the center of thevehicle interior.For example, when a car type has the front speakernearer to the center of the vehicle interior than therear speaker, you hear a delayed sound from therear speaker.This function allows the sound of the nearerspeaker to the center of the vehicle interior to beoutput with delays and compensates the soundarrival time from the front and rear speakers to beheard at the same time.The sound arrival time can be compensated simplyby selecting the car type you want to use, becausethe compensation values for typical cars have beenpreset.You can specify the more suitable compensationvalues for your vehicle by using (page 17)function.You can also compensate the listening positions(such as front and rear) in accordance with scenesby specifying the positions at selection> (page 18).• DTA (Digital Time Alignment)Make fine adjustment of the delay time of thespeaker output specified at (page 17) to have a more suitable environment foryour vehicle.The settings of the delay time are automaticallyidentified and compensated by specifying thedistances of each speaker from the center of thevehicle interior.1 Set the front and rear positions and the heightof the reference point to the position of the earsof the person sitting in the front seat, and setthe right and left positions to the center of thevehicle interior.2 Measure the distances from the reference pointto the speakers.3 Calculate the distance difference in accordancewith the farthest speaker.FRONTFRONTSUB-WREARREARThe marking of products using lasers(Except for some areas)CLASS 1LASER PRODUCTThe label is attached to the chassis/case and saysthat the component uses laser beams that have beenclassified as Class 1. It means that the unit is utilizinglaser beams that are of a weaker class. There is nodanger of hazardous radiation outside the unit. PreviousNext |