Kenwood DPX-MP6110U Instruction Manual

6 | DPX-MP6110UCategory Item Setting Entry Setting overview Condition PageMENU “Security Set”/“Security Clear”1 sec. Sets/Resets security code 15“SRC Select” “1”*/ “2” Sets the source selection method. 24“iPod Mode” “OFF”/ “ON”* When set to “ON”, allows you to select music in the mannersimilar to that of the iPod.12“AT COL CHG” “OFF”/ “iPod”* When the iPod source is used, sets whether the illuminationcolor is changed by the iPod.24“Beep” “OFF”/ “ON”* Setting the operation check sound (beep sound) ON/OFF.“Clock Adjust” 1 sec. Sets the clock. — 16“Date Adjust” 1 sec. Sets the date. 16“Date Mode” 7 types 1 sec. Sets the date display mode.“DSI” “OFF”/ “ON”* A red indicator will blink on the unit after the ACC is set toOFF, warning potential thieves.“Display” “OFF”/ “ON”* Turns off the display when no operation is performed. — 24“Dimmer” “OFF”/ “ON”* Dims the display part in conjunction with the light switchof the vehicle.“ILM Dimmer” “AUTO”*/ “MNAL”/“OFF”Sets whether the illumination is dimmed in conjunctionwith the light switch of the vehicle or it is dimmedconstantly.24“ILM Effect” “OFF”/ “ON”* Sets whether the illumination color is changed inconjunction with the key operation. (To connect theBluetooth unit)“ILM MSC SYNC” “OFF”*/ “ON” Sets whether the key illumination color is changed inconjunction with the sound volume.—“SWPRE” “Rear”*/ “Sub-W” Sets the preout output. 24“AMP” “OFF”/ “ON”* Turns on/off the built-in amplifier. 24“Zone2” “Rear”*/ “Front” Specifies the destination of AUX input sound when the DualZone function is turned on.24“Supreme” “OFF”/ “ON”* Turns ON/OFF the Supreme function. 24“AMS Control” 1 sec. Controls the connected LX amplifier. — 16“CRSC” “OFF”/ “ON”* Switches to Monaural to decrease noise when reception ispoor.“Name Set” 1 sec. Sets the station name (SNPS)/ disc name (DNPS)/ AUX name. 10/11“Chinese” “OFF”*/ “ON” Selects Chinese as the display language. 24“Scroll” “Auto”*/ “Manual” Specifies whether the text is scrolled automatically. —“Built in AUX” “OFF”/ “ON”* Sets whether to display AUX during source selection.“CD Read” “1”*/ “2” Sets the CD read mode. 25“DISP REVERSE” “POSI 1”/ “POSI 2”/“NEGA 1”*/ “NEGA 2”Switches the panel display between positive or negative. — 25“CONTRAST” “1” – “10” Adjusting the display contrast. —“OPENING MSGEEdit”1 sec. Sets the opening message displayed when the power isturned on.11“DEMO Mode” “OFF”/ “ON”* 2 sec. Specifies whether to enable demonstration. — 16SOUND “S-SET” “CABIN” “Compact1” etc. Selects the car type to compensate the distance differencebetween each speaker.17/25“DTA” Makes fine adjustment of the compensation value specifiedat Cabin.17/25“XOVER” Makes fine adjustment of the X’Over value specified atSpeaker.18Function ControlFunctions in the table below can be set up by using Function Control.