English | 19 Audio Preset Memory Registering the value setup by Sound Control. The memory cannot be erased by the Reset button. 1 Setup Sound Control Refer to the following operations to setup the Sound Control. - Cabin selection (page 17) - DTA (Digital Time Alignment) setting (page 17) - X’Over setting (page 17) - Equalizer Control (page 18) - Preset position selection (page 18) - Manual position setting (page 19) 2 Enter Audio Preset Memory mode Select “SOUND” > “PRESET” > “MEMO”. For how to select Function Control item, refer to (page 6). Audio Preset Recall Recalling the sound setup registered by Preset Memory> (page 21). 1 Select the source For how to select source item, refer to Source Select button> of (page 4). 2 Enter Audio Preset Recall mode Select “SOUND” > “PRESET” > “RECALL”. For how to select Function Control item, refer to (page 6). 3 Recall the Audio Preset Press the Control knob. “Recall?” is displayed. 4 Turn the Control knob to select “YES”, and then press the Control knob. “Recall Completed” is displayed. 5 Exit Audio Preset Recall mode Press the [FNC] button. ⁄ • The User memory of “SYSTEM Q” in (page 18) is changed to the value which was recalled. • The source tone memory item of (page 18) is changed to the value which was recalled by the selected source. Manual position setting Making fine adjustment of the value specified at Preset position selection per speaker. 1 Enter Position setting mode Select “SOUND” > “S-CTRL” > “POSIT” > “M-POSI”. For how to select Function Control item, refer to (page 6). 2 Select the Position you want to adjust Item Setting overview “Front Lch” Front Left speaker “Front Rch” Front Right speaker “Rear Lch” Rear Left speaker “Rear Rch” Rear Right speaker “Sub Lch” Subwoofer Left “Sub Rch” Subwoofer Right Turn the Control knob and push the center when the desired item is displayed. 3 Adjust the speaker Turn the Control knob. Adjust between 0 and 170 cm. 4 Exit Position setting mode Press the [FNC] button. ⁄ • When you select “User” at (page 18), the adjusted setting value will be recalled. 3 Put the Audio Preset in the memory Press the Control knob. “Memory?” is displayed. 4 Turn the Control knob to select “YES”, and then press the Control knob. “Memory Completed” is displayed. 5 Exit Audio Preset mode Press the [FNC] button. ⁄ • Register 1 pair of Audio Preset Memory. You cannot register by the source. • When you press the Reset, all the sources will be the setting value which is registered. Previous Next