Kenwood KDC-8080R Instruction Manual

Also see for KDC-8080R: Service manual

Kenwood KDC-8080R Instruction Manual Manual pdf 14 page image

“HPF Rear” : Adjust the frequency of the High-pass filter for rearoutput.Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /150Hz / 180Hz / 220HzYou can separately set the high-pass filter for front and rearoutput, including preouts. The high-pass filter works exceptduring non-fading preout when switching to non-fading (KDC-8080R only). The factory default settings for front output and rearoutput are "through" .NOTE“HPF Front” : Adjust the frequency of the High-pass filter forfront output.Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /150Hz / 180Hz / 220HzYou can separately set the high-pass filter for front and rearoutput, including preouts. The high-pass filter works exceptduring non-fading preout when switching to non-fading (KDC-8080R only). The factory default settings for front output and rearoutput are "through" .NOTE“NFpre Level” : Adjust the Non-fading output level.Setting values: - 15 – + 15• This mode is available only when the non-fading output functionis set to on. (KDC-8080R only)• Not available during the Dual zone system is on.NOTE“Fader” : Adjust the fader level.Setting values: Front 15 – Rear 15“Balance” : Adjust the balance level.Setting values: Left 15 – Right 15“Tre” : Adjust the treble level.Setting values: - 8 – + 8“Tre Frq” : Adjust the centre frequency of the treble.Setting values: 10.0 / 12.5 / 15.0 / 17.5 kHzThis mode is available only when the Sound coordinate system ison. (page 36).NOTE“Bass EXT” : Switch the Bass Extend mode on/off.Setting values: ON / OFF(When the bass extend mode is set to on, lowfrequency response is extended by 20%.)This mode is available only when the Sound coordinate system ison. (page 36)NOTEGeneral features— 14 —English