Kenwood KDC-8080R Instruction Manual

Also see for KDC-8080R: Service manual

Kenwood KDC-8080R Instruction Manual Manual pdf 45 page image

— 45 —Refer to the section "Removing the faceplate (page 12)" andthen reattaching the faceplate.Never insert the taptite screws (ø2 × 6 mm) in any other screwholes than the one specified. If you insert it in another hole, itwill contract and may cause damage to the mechanical partsinside the unit.2CAUTION3Attaching Steering Remote ControlAttach the operation section and the light emitting section of theSteering Remote Control as shown above.Be sure to attach them to positions that can ensure properoperation.• Clean dirt and oil from the positions where the SteeringRemote Control sections are to be attached.• If the attached position is cold, warm it before attaching.• The position should be selected so that the product does notcome in the way of steering operation.• Do not attach anything on the surface of a steering wheelincorporating an air bag.• Before finally affixing the transmitter, check various angles tofind an orientation that provides faithful operation.2CAUTIONMounting Example6987Locking the faceplate to the unitIf you want to lock the faceplate to the unit so that it does notfall off, follow the directions below.Refer to the function "Removing the faceplate (page 12)" andremove the faceplate.Insert the provided screw into the hole at the centre of thebottom side of the faceplate which you have removed fromthe unit.21Accessory5Locking the faceplate to the unitn