Kenwood KDC-BT948HD Instruction Manual

Also see for KDC-BT948HD: Brochure & specs Quick start guide

Contents

46 | KDC-X995/ KDC-BT948HDDSP Setup7 Exit Audio Control modePress the [MENU] button for at least 1 second.Audio Preset MemoryRegistering the value setup by Sound Control.1 Setup Sound ControlRefer to the following operations to setup theSound Control.- Car Type Selection (page 44)- Speaker Setting (page 44)- Car Type Fine Adjustments (page 45)- X’Over Setting (page 46)- Manual Equalizer Control (page 41)- Listening Position Selection (page 42)- Listening Position Fine Adjustments (page 42)2 Enter Audio preset memory modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “Detailed Setup” > “Preset” > “Memory”.3 Select the number to put in the memoryTurn the [VOL] knob and press it when thedesired item is displayed.Select a preset number.4 Turn the [VOL] knob and press it when thedesired item is displayed.Select “YES”.“Memory Completed” is displayed.5 Exit Audio Control modePress the [MENU] button for at least 1 second.⁄• Register 2 patterns of Audio Preset Memory.• Preset number “1”:When you press the Reset, all the sources will be thesetting value which is registered.• Preset number “1” and “2”:The memory cannot be erased by the Reset button.• This function cannot be registered when the iPodEqualizer set in Equalizer curve Select> (page 41).X’Over SettingFine adjusting the following setting valuescorresponding to the X’Over values set in thesection (page 44).Display Item Range“X’Over”“Front” “FC” Front High Pass FilterThrough, 30*, 40, 50*, 60, 70, 80,90*, 100, 120, 150, 180, 220, 250*(Hz)“SLOPE”* Front High Pass Slope-6, -12, -18, -24 dB/Oct“Rear” “FC” Rear High Pass FilterThrough, 30*, 40, 50*, 60, 70, 80,90*, 100, 120, 150, 180, 220, 250*(Hz)“SLOPE”* Rear High Pass Slope-6, -12, -18, -24 dB/Oct“SubWoofer” “FC” Subwoofer Low Pass Filter30*, 40, 50*, 60, 70, 80, 90*, 100,120, 150, 180, 220, 250*, Through(Hz)“SLOPE”* Subwoofer Slope-6, -12, -18, -24 dB/Oct“PHASE” Subwoofer PhaseReverse (180°)/ Normal (0°)( : Factory setting)* Function of KDC-X9951 Select the sourcePressing the [SRC] button repeatedly switchessource.Select a source other than “STANDBY”.2 Enter Audio Control modePress the [VOL] knob.3 Enter X’Over setting modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “Detailed Setup” > “X’Over”.4 Select the speaker you want to setTurn the [VOL] knob and press it when thedesired item is displayed.Select “Front”, “Rear”, or “SubWoofer”.5 Select the item you want to setOperation type OperationSelects the item. Turn the [VOL] knob.Adjust each item. Press the [4] or [¢] button.Set the value Press the [VOL] button.6 Repeat steps 3 to 4 to complete the X’Oversettings.