Kenwood KDC-W8534 Instruction Manual

Also see for KDC-W8534: Service manual

Kenwood KDC-W8534 Instruction Manual Manual pdf 11 page image

English | 11AttenuatorTurning the volume down quickly.Press the [ATT] button.Each time you press the button, the Attenuatorturns ON and OFF.When the Attenuator is ON, "ATT" is displayed.Audio Control1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [VOL] knob.3 Select the Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeRear Volume * 1 "Rear Volume" 0 — 35Subwoofer level*2,3 "Sub-W Level" –15 — +15Balance "Balance" Left 15 — Right 15Fader*3 "Fader" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)• *1 You can control this item when "2 ZONE" of Setup> (page 12) is set to "ON".• *2 You can control this item when Speaker SelectSubwoofer of (page14) is set to any item other than "None".• *3 You can control this item when Output> (page 11) is set to "SW ON".• *3 You can control this item when "2 ZONE" of Setup> (page 12) is set to "OFF".5 Exit Audio Control modePress any button.Press a button other than the [VOL] knob, [ANG]and [ATT] button.Subwoofer OutputTurning the Subwoofer output ON or OFF.Push the Control knob toward [AM] for atleast 2 seconds.Each time you press the button, Subwooferoutput switches ON and OFF.When it is ON, "SW ON" is displayed.• You can control this item when Speaker SelectSubwoofer of (page14) is set to any item other than "None".• You can control this function when "2 ZONE" of