26 | KDC-XBT8013U/ KDC-XBT8013UL/ KDC-X7013U/ KDC-X7013ULDTA (Digital Time Alignment) settingAdjusting fine tuning of the speaker positioncompensation value specified at (Page 25).1 Enter DTA setting modeSelect “SOUND” > “Setup” > “DTA”.For how to select Function Control item, refer to (page 6).2 Select the speaker you want to setSetting speaker DisplayFront speaker “Front”Rear speaker “Rear"Subwoofer “SW"Turn the Control knob.3 Set the compensation value of the speakerpositionTurn the Control knob and push the centerwhen the desired value is displayed.Adjust between 0 and 440 cm.Refer to “DTA” of how to set the compensation value.Exit DTA setting mode.Sound SetupX’Over settingFine adjusting the following setting valuescorresponding to the X’Over values set in thesection (Page 25);Adjustment Item Display RangeFront High Pass Filter,Rear High Pass Filter“FC” Through, 30, 40, 50, 60, 70,80, 90, 100, 120, 150, 180,220, 250 (Hz)Front High Pass Slope,Rear High Pass Slope,Subwoofer Slope“SLOPE” -6, -12, -18, -24 dB/OctSubwoofer Low PassFilter“FC” 30, 40, 50, 60, 70, 80, 90,100, 120, 150, 180, 220, 250,Through (Hz)Subwoofer Phase “PHASE” Reverse (180°)/ Normal (0°)1 Enter X’Over setting modeSelect “SOUND” > “Setup” > “X’Over”.For how to select Function Control item, refer to (page 6).2 Select the speaker you want to setSetting speaker DisplayFront speaker “Front”Rear speaker “Rear"Subwoofer “Subwoofer"Turn the Control knob and push the centerwhen the desired item is displayed.3 Select the item you want to setItem Setting overview“Front” >“FC”>“SLOPE”Front High Pass FilterFront High Pass Slope“Rear" >“FC”>“SLOPE”Rear High Pass FilterRear High Pass Slope“Subwoofer" >“FC”>“SLOPE”>“PHASE”Subwoofer Low Pass FilterSubwoofer SlopeSubwoofer PhasePush the Control knob towards up or down.4 Set the X’Over valueTurn the Control knob.5 Repeat steps 2 to 4 to complete the X’Oversetting.6 Exit X’Over setting modePress the [FNC] button.
