Kenwood KDC-X7013U Instruction Manual

English | 45Connecting Wires to TerminalsP.CONTILLUMIANT.CONTMUTE–+REMO.CONTLRLRFM/AM antenna inputFront outputFuse (10A)Microphone(Accessory5)White/BlackGray/BlackGreen/BlackPurple/BlackWhiteGrayGreenPurpleTo front left speakerTo front right speakerTo rear right speakerTo rear left speakerIgnition wire (Red)Battery wire (Yellow)Ground wire (Black) · (To car chassis)Ignition keyswitchCar fuse box(Main fuse)ACCCar fuseboxBatteryIf no connections are made, do not let the wire come out from the tab.Power control wire (Blue/White)Motor antenna control wire (Blue)Dimmer control wire (Orange / White)When using the optional power amplifier, connect to its power controlterminal.To car light control switchDepending on what antenna you are using, connect either to the controlterminal of the motor antenna, or to the power terminal for the boosteramplifier of the film-type or short pole type antenna.Sub Woofer outputTEL mute wire (Brown)Rear output⁄ To use the steeringwheel remote controlfeature, you need toan exclusive remoteadapter (not supplied)matches your car isrequired.Steering remote control(Light Blue/Yellow)To Kenwood disc changer/ External optional accessory⁄ To connect these leads, refer to the relevantinstruction manuals.Connect to the terminal that is grounded when either the telephonerings or during conversation.⁄ To connect the Kenwood navigation system, consult yournavigation manual.USB connector (1m)To USB device⁄ Do not remove the cap when you donot use the USB cable. The connectorwill cause the unit to malfunction if itgets in touch with any metallic part ofthe vehicle.Wiring harness(Accessory1)Microphone input(KDC-XBT8013U/KDC-XBT8013UL only)AUX input (Stereo)Use the mini-plug which is stereo typeand does not have any resistance.