NX-3003SYSTEM SET-UPMerchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverTransceiver programmingAre you using the optional antenna?Are you using the speaker microphone?A personal computer (IBM PC or compatible), programming interface(KPG-36/36A), USB adapter (KCT-53U), and programming software (KPG-111D)are required for programming.(The frequency, and signaling data are programmed for the transceiver.)Frequency range (MHz) RF power Type DTMF keypadTX/RX 450~520 5W NX-300 K NoNoTX/RX 400~470 5W NX-300 K2YesTX/RX 450~520 5W NX-300 K3YesTX/RX 400~470 5W NX-300 K4YES KRA-23 or KRA-27Optional antennaNONO(Option)(Option)YES KMC-25Speaker microphoneorKMC-38GPSGPS speaker microphoneAre you using the voice guide & storage unit?NO (Option)YES VGS-1DeliveryREALIGNMENT1. ModesUser modePanel test modeFirmware version informationPanel tuning modeData programming modePC test mode PC tuning modePC modeClone modeFirmwareprogramming modeMode FunctionUser mode For normal use.Panel test mode Used by the dealer to check the fundamen-tal characteristics.Panel tuning mode Used by the dealer to tune the transceiver.PC mode Used for communication between the trans-ceiver and PC.Data programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test modeUsed to check the transceiver using the PC.This feature is included in the FPU.See pages 45 to 57.Firmware program-ming modeUsed when changing the main program ofthe flash memory.Clone mode Used to transfer programming data fromone transceiver to another.Firmware versioninformationUsed to confirm the internal firmware ver-sion.