Kenwood NX-300 Service Manual

Also see for NEXEDGE NX-300: Brochure Instruction manual Instruction manual Instruction manual Instruction manual

NX-3006If you press the [ ] key after entering the password inthis procedure, “CLONE MODE” is displayed if the en-tered password is correct. If the password is incorrect,“CLONE LOCK” is redisplayed.4. Power ON the target transceiver.5. Connect the cloning cable (part No. E30-3325-05) to theuniversal connectors on the source and target.6. Press the [ ] key on the source while the source displays“CLONE MODE”. The data of the source is sent to thetarget. While the target is receiving the data, “PRO-GRAM” is displayed. When cloning of data is complet-ed, the source displays “END”, and the target automati-cally operates in the User mode. The target can then beoperated by the same program as the source.7. The other target can be continuously cloned. When the[ ] key on the source is pressed while the source dis-plays “END”, the source displays “CLONE MODE”.Carry out the operation in step 4 to 6.Notes:• Cannot be cloned if the password (overwrite password)is programmed to the target.• “Model Name” must be same to clone the transceiver.REALIGNMENTCloning cable(E30-3325-05)1247MIC1247MICFig. 28. Firmware Version InformationPress and hold the [Side1] key while turning the trans-ceiver power ON and then keep pressing and holding the[Side1] key, the firmware version information appears on theLCD.DISASSEMBLY FOR REPAIR1. Precautions for Waterproof• Do not remove the black sheet from the reverse side ofthe transceiver (refer to the illustration right). Removalof this sheet decreases the waterproof efficiency of thetransceiver and may cause malfunctions if water seepsinto the transceiver.• The orange packing material on the reverse side of thetransceiver is important with respect to the waterproofefficiency of the transceiver. Do not place stickers orother materials on or around the packing material shownin the figure, or on the reverse side of the battery pack.Doing so will impair the waterproof efficiency of thetransceiver and may cause it to break down. Additionally,in order to prevent damage to the packing material, donot allow it to come in contact with foreign materials.