Kenwood NX-300 Service Manual

Also see for NEXEDGE NX-300: Brochure Instruction manual Instruction manual Instruction manual Instruction manual

NX-30037■ Key operationKey “FNC” not appears on the sub LCD displayFunction Display[Selector] - -[ ]Push: Test channel upHold: Test channel upcontinuouslyChannel No.[ ]Push: Test channel downHold: Test channel downcontinuouslyChannel No.[Side1] Push: Squelch level upHold: Squelch offSquelch levelSquelch off: icon appears[Side2] Wide/Narrow/Very narrowWide: “w”Narrow: “n”Very narrow: “v”[ ] Shift to panel tuning mode -[ ] Function on “FNC” appears on the subLCD display[ ] MSK 1200bps and 2400bps 2400bps: icon appears[ ]Push: Test signaling upHold: Test signaling upcontinuouslySignaling No.[Orange] - -[PTT] Transmit -[0] to [9]and[#], [ ]Use as the DTMF keypad.If a key is pressed duringtransmission, the DTMFcorresponding to the keythat was presses is sent.-Key “FNC” appears on the sub LCD displayFunction Display[Selector] -[ ] Function off -[ ] Analog/NXDN Analog: “A”NXDN: “N”[Side1] Function off -[Side2] LCD all lights LCD all point appears[ ] High power/Low power High: “H”Low: “L”[ ] Function off -[ ] Compander on/off On: icon appears[ ] Beat shift on/off On: icon appears[Orange] Function off -[PTT] Transmit -[0] to [9]and[#], [ ]Function off -• LED indicatorRed LED Lights during transmission.Green LED Lights when there is carrier.• Sub LCD indicator“FNC” Appears at function on.• LCD display in panel test mode(Power ON)Battery type detect“LI NML”: Li-ion normalcapacity battery“LI HI”: Li-ion highcapacity battery“ IS”: IS Ni-MH batteryMarket code Frequency range“F1”: 450~520MHz“F2”: 400~470MHz(After 2sec.)Temperature PowerSub LCD displayMain LCD displayChannel No. Signaling No.Squelch level(Analog mode only)An: Analog narrow modeAw: Analog wide modeNn: NXDN narrow modeNv: NXDN very narrow mode■ Frequency and SignalingThe transceiver has been adjusted for the frequenciesshown in the following table. When required, readjust themfollowing the adjustment procedure to obtain the frequen-cies you want in actual operation.• Test frequencyCH K,K3 K2,K4RX (MHz) TX (MHz) RX (MHz) TX (MHz)1 485.05000 485.10000 435.05000 435.100002 450.05000 450.10000 400.05000 400.100003 519.95000 519.90000 469.95000 469.900004 485.00000 485.00000 435.00000 435.000005 485.20000 485.20000 435.20000 435.200006 485.40000 485.40000 435.40000 435.400007~16 - - - -ADJUSTMENT