1-46 (No.RA015)3.TransmitAssist1) Adj item:[TAST]Adjust:[****]2) Adj item:[Low1 TAST]→[Low2 TAST]→[Low3 TAST]→[Low4 TAST]→[Low5 TAST]→[Low6 TAST]→[Center1 TAST]→[Center2 TAST]→[Center3 TAST]→[Center4 TAST]→[Center5 TAST]→[High1 TAST]→[High2 TAST]→[High3 TAST]→[High4 TAST]→[High5 TAST]→[High6 TAST]→*F5,F6,K5,K6type only:Press and holdthe [] key toenter[Center1TAST](OverLap High)→Adjust:[****]Press [ ] keyto store the ad-justment val-ue.1) Adj item:[Transmit Assist]2) Adj item:[Low1],[Low2],[Low3],[Low4],[Low5],[Low6],[Center1], [Center2],[Center3], [Center4],[Center5],[High1],[High2][High3],[High4][High5],[High6]*F5,F6,K5,K6 typeonly:[Center1 TAST](OverLap High)→Press [Apply All] but-ton to store the ad-justment value.Panel [Paneltuningmode][],[][PCtestmode][←],[→][PC test mode][Automatic Adjust-ment]1) Press [Tune AssistVoltage] button.2) Press [Apply All] but-ton to store the adjust-ment value after theautomatic adjustmenthas finished.[Manual Adjustment][V] indicator on the PCwindow shows VCO lockvoltage. Change the ad-justment value to getVCO lock voltage withinthe limit of the specifiedvoltage.Note:Confirm the VCO lockvoltage approximately3 seconds after theadjustment value ischanged.2.5V±0.1V[Automatic Ad-justment]After the automaticadjustment is per-formed, verify thatthe VCO lock volt-age is within thevoltage rangewhich is specifiedby the manual ad-justment.[Manual Adjust-ment]Press [Apply All]button to store theadjustment valueafter all adjustmentpoint have beenadjusted.Note:The assist adjust-ment value mustbe between from340 to 3550.Item Condition Measurement Adjustment Specifications/RemarksPanel tuningmodePC test mode Test-equip-mentUnit Ter-minalUnit Parts Method
