1-8 (No.RA015)word is correct. If the password is incorrect, “Input Pass-word” is redisplayed.(4) Power ON the target transceiver.(5) Connecting the cloning cable (part No.E30-3325-05) to theuniversal connectors on the source and target.(6) Press [ ] key on the source while the source displays“CLONE MODE”. The data of the source is sent to the tar-get. While the target is receiving the data, “PROGRAM” isdisplayed. When cloning of the data is completed, thesource displays “END”, and the target automatically oper-ates in the User mode. The target can then be operated bythe same program as the source.(7) The other target can be continuously cloned. When the[ ] key on the source is pressed while the source displays“END”, the source displays “CLONE MODE”. Carry out theoperation in step (4) to (6).Note:• Cannot be cloned if the password (overwrite password) isprogrammed to the target.• “Model name” must be same to clone the transceiver.Fig.22.2.8 Front Panel Programming ModeIf the Front Panel Programming Mode is used, the frequency orother data of the conventional channel is rewritable only by thetransceiver.Moreover, the conventional channel can be added.The following setup items can be changed or added by us-ing the Front panel programming mode.• RX/TX Frequency• Channel Type• Channel Spacing• Decode QT/DQT/RAN/NAC, Encode QT/DQT/RAN/NAC• Talkgroup ID List No.• Transmit Power• Channel NameKey guide on the Clone/ Front Panel Programming Pass-word input screen.• Confirm ([ ] key): The password confirmation• Delete ([ ] key): Delete the latest digit from the currentpassword number (Press and hold to delete all passwordnumbers)• Select ([ ] key): Determine the latest digit of the passwordnumber.2.2.8.1 Enter to the Front panel programming mode.Enter to the Menu Mode by pressing [Front Panel Mode] PF keyor [Menu] key. When the Front Panel Mode is selected, it can en-ter to the Front panel programming mode.If the Clone/Front panel programming Password is not set to thetransceiver, "Panel Program" is displayed on the LCD.If the Clone/Front panel programming Password is set to thetransceiver, "Panel Program" is displayed on the LCD when youenter the correct password while “Input Password” is displayed.2.2.8.2 Data WritingBefore moving to next Zone/Channel, “Keep This Change?” ap-pears on the LCD, if you select “OK”, the new data is written tomemory. If you select “Cancel”, the new data not be written; thenew data will be erased.• The setup items for Front panel programming mode are asfollows.Cloning cable(E30-3325-05)SourcetransceiverTargettransceiverNo. Setup item Display Remarks1 RX Frequency RX Frequency Receive Frequency2 TX Frequency TX Frequency Transmit Frequency3 Channel Type Channel Type Analog/NXDN/P254 ChannelSpacingChannel Space Analog:12.5kHz/20kHz/25kHzNote: 20kHz is appliedfor E and E2 types only.NXDN:6.25kHz/12.5kHzP25: 12.5kHz5 RX Signaling RX QT/DQT Receive QT/DQT6 TX Signaling TX QT/DQT Transmit QT/DQT7 RX RAN RX RAN None, 1~638 TX RAN TX RAN None, 1~639 RX NAC RX NAC 000~FFF(Hexadecimal)Note: “F7F” cannot set.10 TX NAC TX NAC 000~FFF(Hexadecimal)Note: “F7F” cannot set.11 Talkgroup IDList NumberTalkgroup None, 1~150012 Transmit Power TransmitPowerLow/Medium/High13 Channel Name Channel Name
