(No.RA020)1-11• Front panel programming mode flow chartInput PasswordFront panel Programming modetceleSenoZ?egnahCsihTpeeKtceleSlennahCemaNlennahCTransmit Power Low Medium High Blank Channel Select the setting channel.Zone-Channel Formatis "Personality"."System Type = Conventional"there is more than two.System Select Analog P25RX FrfequencyFFOycneuqerFXTgolanAepyTlennahC12.5kHz 25.0kHz 20.0kHzWhen the KPG-D1N is used, 25.0kHz may not be alloweddepends on the frequency (F, K types only).Channel Spacing 12.5kHzRX Signaling OFF QT DQT N DQT ITX Signaling OFF QT DQT N DQT IRX NACTX NACTalkgroup ID List Nu mberP25NXDN[Channel Type]:"P25","Mixed"(Transmit Mode:P25) andwhen two kinds of Channel Type is set.[Channel Type]: "Analog"[TX Frequency]: "OFF"[Channel Type]: "Analog"[Channel Type]: "Analog","Mixed"(Transmit Mode: NXDN),"Mixed"(Transmit Mode: P25) and when a kind of Channel Type is set.[TX Frequency]: Other than "OFF"[Channel Type]: "Analog","Mixed"(Transmit Mode: NXDN),"Mixed"(Transmit Mode: P25)Clone/Front Panel Password[TX Frequency]: Other than "OFF"[Channel Type]: "P25","Mixed"(Transmit Mode: P25)Talkgroup List ID Amount: 0 [Channel Type]: "P25","Mixed"(Transmit Mode: P25)Talkgroup ID List Amount must not be 0.RX RANTX RANNXDN[TX Frequency]: "OFF"[Channel Type]: "P25"[System Type]: "P25"[System Type]: "NXDN"6.25Hz[Channel Type]: "NXDN","Mixed"(Transmit Mode: NXDN)[ ][ ][ ] or [ ][No][No][Channel Type]: "Analog","Mixed"(Transmit Mode: NXDN),"Mixed"(Transmit Mode: P25)[ ][ ][ ][ ][ ][ ][ ][ ][ ][ ][ ][ ][ ][ ][ ][ ][TX Frequency]: Other than "OFF"[Channel Type]: "NXDN","Mixed"(Transmit Mode: NXDN)[Channel Type]: "NXDN","Mixed"(Transmit Mode:NXDN) andwhen two kinds of Channel Type is set.[ ][ ][ ][TX Frequency]: "OFF"[Channel Type]: "NXDN"[ ][Channel Type]: "NXDN","Mixed"(Transmit Mode: NXDN)[ ][ ] or [ ] [ ] or [ ][ ] or [ ]Mixed[System Type]: "P25" or ”NXDN” and [Channel Type]: "Mixed"[ ] or [ ][ ] or [ ][ ] or [ ][ ] or [ ][ ] or [ ] [ ] or [ ] [ ] or [ ][ ] or [ ] [ ] or [ ] [ ] or [ ]Enter the Front panel programming modeby using section "2.2.2 How to Enter Each Mode".[ ]Note: Zone-Channel Format allows you to whether to configure for each zone the channels in the same system, or channels in different system.P25 can be configured for System Select or Channel Type if one or more P25 conventional system is preconfigured by the FPU.[ ] or [ ][ ] or [ ]Transmit Mode select golanAP25NXDN[System Type]: "P25"[System Type]: "NXDN"[ ] or [ ][ ] or [ ][ ] or [ ][ ] or [ ][Channel Type]: "Mixed" andwhen Channel Spacing in two kinds of Channel Type is set.
