1-64 (No.RA020)*3: When the mode is selected as P25, this function is enabled.• LED indicatorRed LED Lights during transmission.Green LED Lights when there is carrier.• Sub LCD indicator"Func" Appears at function on.• LCD display in panel test mode4.12.3 Frequency and SignalingThe transceiver has been adjusted for the frequencies shown inthe following table. When required, readjust them following theadjustment procedure to obtain the frequencies you want in ac-tual operation.(1) Test frequency(2) Test signalingAnalog mode signaling[ ] High power/Mediumpower/Low powerHigh: "H"Medium: "M"Low: "L"[ ] Function off -[ ] Compander on/off On: icon appears[ ] External Speaker on/off On: icon appears[AUX(Orange)]Function off -[PTT] Transmit -Key "Func" appears on the sub LCD displayFunction Display[0] to [9]and[#], [ ]Function off -Key "Func" appears on the sub LCD displayFunction Display(Power ON)Type Frequency range136~174MHz(After 2sec.)TemperaturePowerAn : Analog narrow modeAw : Analog wide 5k modeAs : Analog wide 4k modeP1 : P25 Phase1 modeP2 : P25 Phase2 modeNn : NXDN narrow modeNv : NXDN very narrow modeSquelch level(Analog mode only)Sub LCD displayMain LCD display SignalingNo.Channel No.CH RX (MHz) TX (MHz)1 155.05000 155.100002 136.05000 136.100003 173.95000 173.900004 155.00000 155.000005 155.20000 155.200006 155.40000 155.400007~16 - -No. RX TX1 None None2 None Square Wave3 LTR Data LTR Data4 QT:67.0Hz QT:67.0Hz5 QT:151.4Hz QT:151.4Hz6 QT:210.7Hz QT:210.7Hz7 QT:254.1Hz QT:254.1Hz8 DQT:D023N DQT:D023N9 DQT:D754I DQT:D754I10 DTMF Decode(CODE: 159D)DTMF Encode(CODE: 159D)11 None DTMF Encode (CODE: 9)12 2-tone Decode(A: 304.7Hz, B: 3106.0Hz)2-tone Encode (A: 304.7Hz,B: 3106.0Hz)13 Single Tone Decode(979.9Hz)Single Tone Encode(979.9Hz)
