Kenwood NXR-710 Service Manual

Also see for NEXEDGE NXR-710: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

NXR-71040Test ChannelNo. RX TX1 155.050000MHz 155.100000MHz2 136.050000MHz 136.100000MHz3 173.950000MHz 173.900000MHz4 155.000000MHz 155.000000MHz5 155.200000MHz 155.200000MHz6 155.400000MHz 155.400000MHz7~16 Blank BlankADJUSTMENTTest Signaling (Analog)No. RX (Decode Signaling) TX (Encode Signaling)1 None None2 None 100Hz Square Wave3 QT 67.0Hz QT 67.0Hz4 QT 151.4Hz QT 151.4Hz5 QT 210.7Hz QT 210.7Hz6 QT 254.1Hz QT 254.1Hz7 DQT D023N DQT D023N8 DQT D754I DQT D754I9 None CWID Encode (ID: VVV)10 None Single Tone11 DTMF Decode (CODE: 159D) DTMF Encode (CODE: 159D)12 None DTMF Encode (CODE: 9)13 None Courtesy ToneTest Signaling (NXDN)No. RX (Decode Signaling) TX (Encode Signaling)1 RAN 1 RAN 12 RAN 1 PN 93 RAN 1 Maximum Deviation Pattern• Signaling number 1 is used for link test.• Signaling number 2 is used for TX modulation signal qual-ity test. i.e, TX adjacent channel power, FSK error, Occu-pied bandwidth, Emission mask, etc.• Signaling number 3 is used for TX deviation test. If themodulation mode is very narrow, the modulation fre-quency is 600Hz. If the modulation mode is narrow, themodulation frequency is 1200Hz.Adjustment PointsRX_CVRX_AST2nd_LoLDTMB MB_CV2MOTX_ASTTX_CVLDR450kHzASWCMODVOUT4VOUT7TX-RX UNITComponent side