Kenwood NXR-710 Service Manual

Also see for NEXEDGE NXR-710: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

NXR-71061. External Speaker (KES-5)The NXR-710 has a built-in speaker (5W/8Ω), and theexternal speaker output from the TEST/SPKR connector (15-pin) on the rear of the radio is 4W/4Ω. Use external speakerKES-5.1-1. Connection for the KES-5 with the NXR-710■ When taking the AF output from the TEST/SPKRconnector (15-pin) on the rear of the radioThe following tools are required for changing the connec-tor.• Extracting toolThe following extracting tool is recommended:Molex Inc. Order No.: J5800-002 (W05-0878-00)1. Remove the connector with jumper from the externalspeaker connector on the rear panel of the radio. (Fig.1-1)Note: Save the jumper, which is required when the radiois used without the external speaker.2. Remove the terminals with the jumper from the connec-tor housing holes number 9 and 12 using the extractingtool.Removing the jumper lead (Fig. 1-2)1) Insert the extracting tool (J5800-002) into the connec-tor while pushing the jumper lead in the direction of (a).2) Push the extracting tool in to collapse the barbs of thecrimp terminal.3) Pull out the lead while continuing to push the extract-ing tool in the direction (b).3. Reinsert the terminal with the black and white stripe leadinto hole number 12, and the terminal with the black leadinto hole number 6. (Fig. 1-3)4. Attach the connector to the external speaker connectoron the radio.Note:Relationship between the TEST/SPKR connector (15-pin)connection and speaker output:• When pins 9 and 12 are shorted: The built-in speaker isused.• When pins 9 and 12 are open and output is from pins 6and 12: KES-5 is used.Square-type plug(E31-3228-05)AccessoryFig. 1-1INSTALLATIONJumper leadCrimp termialCrimp termialBarbsExtracting tool(11-03-0002)(a)(b)Fig. 1-2Crimp terminal(E23-0613-05)121513136Black/White leadBlack leadFig. 1-32. Accessory CabinetYou can install optional accessories, such as a DC powersupply or duplexers, in the accessory cabinet.1. Place the optional accessory in the cabinet as shown be-low.2. If necessary, attach cushions (G13-1801-04 and/or G13-1802-04) to the top plate (J21-8559-04) in order to adjustthe space between the cabinet and the top plate. Then,insert the 3 tabs of the plate into the slots in the side ofthe cabinet. High, middle, or low positions are available.To affix the plate, inset and tighten the 2 screws on theother side of the plate.You can also flip the top plate upside-down to adjust theheight of the cabinet space.